TEE 6K8498 - Caterpillar

System Conditions
Table 1
Message Support Load Status Description
Modem: Paging Cancelled. Y Normal Paging was Canceled via UPSView, modem, or user interface.
Modem: Page Failed:_. Y Normal The pager was not able to be dialed, check the phone line and number.
Email Sent OK. Y Normal e-mail message sent to server
EPO Activated (Serial Data). N Error EPO activated via internal serial link.
Modem: Page Sent OK:_. Y Normal Paging was successful.
Email Send Failure. Y Error Unable to send e-mail to mail server, check mail server IP
Cleared Password Enables. Y Service Password cleared via UPSView.
Invalid Access Passcode Entered. Y Service The incorrect access passcode was entered. A modem connection must be established, a service password must be entered, and then the access passcode can be entered.
Modbus: Task Suspending. The Modbus option is enabled but disconnected.
Modbus: Connection Made. The Modbus option is enabled but disconnected.
Accepted service mode password authorized for 30 minutes. Y Normal Service engineer password has been accepted.
Remote EPO Activated. N Error Remote EPO is received by remote panel (hard wired).
Remote Access Enabled. Y Normal All conditions have been met for remote access and the access code has been entered at the User Interface.
_Password accepted authorized for 30 minutes. Y Normal Password accepted.
Modbus: Disconnected. The Modbus option is enabled but disconnected.
Unknown System Message Type Received:_. This message may appear only during a power-down.
Time Changed Y Service Time change entered via UPSView and accepted.
Discharge blocked N Service Discharge locked out by service engineer (manual mode).
Discharge Open. Y/N Service Service engineer has removed the discharge lock out.
EPO Activated. N Error EPO activated via the EPO button on the front door panel.
Event Log Erased. Y Service Event log was erased.
Remote EPO (Serial Data). N Error Remote EPO is received by internal serial link.
Timeout waiting for Static Switch to walk-in. N Error Static switch failed to walking in AC to utility converter, check the static switch module.
Modem Telemetry terminated. Y/N Normal Call ended.
_Field Service password accepted for 30 minutes. Y Normal Service engineers password accepted.
Password key had expired. Y Normal Internal timer causes the password to expire.
Invalid password key entered. Y Error Invalid password has been entered.
APS date is invalid and must be reset. Y Error Password access cannot be granted until date and time are set.
Phase Rotation Bits in invalid state. N Error At start-up the input phases were in an illegal state. Phase rotation must be clockwise.
Modem telemetry initiated Y/N Normal Call received over the modem.
System will not auto-start calibration not complete. N Service Start up or service condition is waiting for completion of calibration. Error Messages
Table 2
Message Support Load Status Description
Input