TEE AS-PIPE 6V0471 - Caterpillar

Diagnostic Codes
Diagnostic codes are used by the electronic system in order to alert the operator that a problem exists. A diagnostic code also indicates the nature of the problem to the service technician.Diagnostic Codes may be viewed by using the Caterpillar Electronic Technician (ET). The Component Identifier (CID) identifies a specific component in the system that is described by the diagnostic code. The Failure Mode Identifier (FMI) indicates the failure mode.Diagnostic Codes may be viewed by a device that uses the J1939 Data Link. The Suspect Parameter Number (SPN) identifies a specific component in the system that is described by the diagnostic code. The Failure Mode Identifier (FMI) indicates the failure mode.The code number will direct you to a procedure in Troubleshooting, "Troubleshooting With A Diagnostic Code". Do not confuse diagnostic codes with diagnostic events. Refer to the Troubleshooting, "Event Codes" section of this manual for further information on event codes.Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International, SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.Active Diagnostic Codes
An active diagnostic code represents a problem with the electronic control system. Correct the condition as soon as possible. If the condition that generates the diagnostic code occurs only for a brief moment, the message will disappear and the diagnostic code will be logged in the memory of the Electronic Control Module (ECM).Logged Diagnostic Codes
When the ECM generates a diagnostic code, the ECM will log the code in the permanent memory of the ECM. The ECM has a diagnostic clock that is internal. This clock records the hour of the first occurrence, the hour of the last occurrence, and the number of occurrences of the code. Knowing the timing of the code and knowing the frequency of the code can be a valuable indicator. These indicators are helpful when problems that are intermittent are being investigated.Note: Cat ET can be used in order to retrieve logged codes and Cat ET can be used in order to erase logged codes. Logged diagnostic codes will automatically be deleted if no additional occurrences are recorded in 100 hours. Be aware of the following information when logged diagnostic codes are investigated.
Some diagnostic codes may log occurrences that did not result in operator complaints. A diagnostic code is logged at a specific time. This time should correlate to a complaint. A repair may not be necessary if there is no correlation.
The most likely cause of an intermittent problem is a faulty connection or damaged wiring. The next most likely cause of an intermittent failure is a component failure such as a sensor or a switch. The least likely cause of an intermittent problem is a failure of the ECM.
Diagnostic codes that are logged repeatedly may indicate a problem that needs special investigation.
The code number will direct you to a procedure in