TERMINAL 2524967 - Caterpillar

3114 Engines and 3116 Engines
Illustration 1 g00580795
3114 Engines and 3116 Engines (1) Injector rocker arm assembly (2) Rocker arm bearing Bore in rocker arm bearing ... 24.802 0.020 mm (0.9765 0.0008 inch) (3) Rocker arm shaft Diameter of new rocker arm shaft ... 24.755 0.010 mm (0.9746 0.0004 inch)Note: The oil holes in the rocker arm bearing must be aligned with the oil holes in the rocker arm. (4) Locknut Tighten the locknut to the following torque. ... 33 7 N m (24 5 lb ft) (5) Fuel timing dimensionNote: Use the following references to obtain the correct fuel timing dimension.
Engine Information Plate
TMI (Technical Marketing Information)
Fuel Setting and Related Information Fiche (6) Support for rocker arm assembly Height of the support ... 70.6 mm (2.78 inch) (7) Push rod for injector The length of the push rod for the injector ... 221 mm (8.7 inch)Note: The length of the push rod (7) for the injector is a total length. This length is measured from the top of the concave end to the bottom of the ball end. The dimension was measured with a scale. The dimension is only a reference dimension. (8) Lifter arm Bore in the lifter arm ... 15.670 0.013 mm (0.6169 0.0005 inch) (9) Shaft for lifter arm Diameter of new shaft for lifter arm ... 15.620 0.018 mm (0.6150 0.0007 inch) 3126 Engines
Illustration 2 g00580992
3126 EnginesNote: Refer to System Operation, Testing and Adjusting for the sequence of the installation and adjustment of the injector mechanism. (1) Injector rocker arm assembly (2) Rocker arm bearing Bore in rocker arm bearing ... 24.802 0.020 mm (0.9765 0.0008 inch) (3) Rocker arm shaft Diameter of new rocker arm shaft ... 24.755 0.010 mm (0.9746 0.0004 inch)Note: The oil holes in the rocker arm bearing must be aligned with the oil holes in the rocker arm. (4) Locknut Tighten the locknut to the following torque. ... 33 7 N m (24 5 lb ft) (5) Fuel timing dimensionNote: Use the following references to obtain the correct fuel timing dimension.
Engine Information Plate
TMI (Technical Marketing Information)
Fuel Setting and Related Information Fiche (6) Support for rocker arm assembly Height of the support ... 77.2 mm (3.04 inch) (7) Push rod for injector The length of the push rod for the injector ... 225 mm (8.9 inch)Note: The length of the push rod (7) for the injector is a total length. This length is measured from the top of the concave end to the bottom of the ball end. The dimension was measured with a scale. The dimension is only a reference dimension. (8) Lifter arm Bore in the lifter arm ... 15.670 0.013 mm (0.6169 0.0005 inch) (9) Shaft for lifter arm Diameter of new shaft for lifter arm ... 15.620 0.018 mm (0.6150 0.0007 inch)