TERMINAL AS-BATTERY 3S6049 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Fuel System - Prime
Fuel System - Prime
Generator - Dry
Generator Load - Check
Generator Set - Test
Rotating Rectifier - Check
Rotating Rectifier - Test
Sea Water Strainer - Clean/Inspect
Severe Service Application - Check
Daily
Cooling System Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Power Factor - Check
Walk-Around Inspection
Every Week
Automatic Start/Stop - Inspect
Bearing Temperature - Measure/Record
Hoses and Clamps - Inspect/Replace
Instrument Panel - Inspect
Jacket Water Heater - Check
Standby Generator Set Maintenance Recommendations
Every 250 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Engine Oil Sample - Obtain
Initial 500 Service Hours
Engine Valve Lash - Inspect/Adjust
Every 500 Service Hours
Belts - Inspect/Adjust/Replace
Belts - Inspect/Adjust/Replace
Engine Crankcase Breather - Replace
Engine Oil and Filter - Change
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Every 500 Service Hours or 1 Year
Auxiliary Water Pump - Inspect
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Air Cleaner Element - Clean/Replace
Radiator - Clean
Sea Water Strainer - Clean/Inspect
Every 1000 Service Hours
Aftercooler Condensate Drain Valve - Inspect/Clean
Engine Valve Lash - Inspect/Adjust
Magnetic Pickups - Clean/Inspect
Water Pump - Inspect
Every 1000 Service Hours or 1 Year
Battery Charger - Check
Every 2000 Service Hours
Engine Mounts - Inspect
Heat Exchanger - Inspect
Insulation - Test
Starting Motor - Inspect
Turbocharger - Inspect
Every 2000 Service Hours or 1 Year
Alternator - Inspect
Generator Set Vibration - Inspect
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 2 Years
Cooling System Coolant (DEAC) - Change
Cooling System Water Temperature Regulator - Replace
Every 3000 Service Hours or 3 Years
Engine Protective Devices - Check
Every 4000 Service Hours
Aftercooler Core - Clean/Test
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Overhaul
Overhaul Considerations