TERMINAL-CABLE 4155650 - Caterpillar

Disassembly Procedure
Start By:
Remove the engine front housing. Refer to Disassembly and Assembly, "Housing (Front) - Remove".
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: If the original front housing will be replaced by a different item, refer to Systems Operation, Testing and Adjusting, "Governor" before disassembling the front housing.
Illustration 1 g01357675
Typical example
Remove spring (4) from arm (2) on the assembly of throttle control (1).
Illustration 2 g01354631
Typical example
Remove bolts (5) and remove the assembly of throttle control (1) from front housing (3).
Remove joint (6).
Illustration 3 g01357717
Typical example
Remove shaft (9) from front housing (3).
Remove lever assembly (7) from front housing (3).
Remove sealing washer (8) from shaft (9).
Illustration 4 g01357689
If the engine is equipped with an angleich unit, remove angleich unit (10) from lever assembly (7).
Illustration 5 g01357693
Typical example
Illustration 6 g01357727
Typical example
Disconnect spring (12) from front housing (3).
Remove nut (14) and remove sealing washer (13) from front housing (3).
Remove shaft (15) and remove lever assembly (11) from front housing (3).
Illustration 7 g01358077
Typical example
Remove spring assembly (17) and remove sealing washer (18) from front housing (3). Note: The position of stop (16) controls the emissions of the engine. Do not remove the stop unless a different front housing will be installed. Do not adjust the stop. Refer to Systems Operation, Testing and Adjusting, "Governor" for further information.
If necessary, remove cap (21), locknut (20) and sealing washer (19) from front housing (3). Remove stop (16).