TERMINAL-CABLE 4160567 - Caterpillar

Illustration 40 g01349433
Screen for the LCG 1Once the software setup is completed, restart the computer in order to update the registry.
Illustration 41 g01349442
Illustration 42 g01349457
Screen for the LCG 1Select the program for the LCG 1 from the menu. The LCG Control Service Tool will appear for a short time. The LCG Control Service Tool will then disappear.This is the first screen that appears when the graphic user interface (GUI) is installed. Refer to illustration 41. To use the GUI flash tool, the user must have a LCG1 with a supported firmware revision. The user must have access to a valid configuration file.
Illustration 43 g01348485
The GUI supports firmware revisions. The dialog box in the center of the screen will indicate that a LC SPD/TOPPING configuration format will be used. If the system has a different configuration format, contact your Caterpillar dealer.IDENTITY CONTROL-. This Identifies the version of Firmware that is used by the LCG. Ensure that theLCG is connected to the computer via a Programming harness. IMPORT CONFIG FILE - opens an existing configuration file. Use the internet browser to select the desired file. (Configuration files use a *.lcs extension.)Note: In working with the LCG, the power must be cycled from time to time. The user will be prompted to turn power to the ON position or to the OFF position. If the power cycle is not completed in ten seconds, a message will appear. The message prompts the user to retry. The message also prompts the current activity to be stopped.Once a valid file or valid LCG has been identified, a screen is displayed. Refer to illustration 41. The box in the center of the screen determines the version of the LCG.
Illustration 44 g01348489
The configuration menu will allow the user to download different configuration files to the LCG.
Illustration 45 g01348500
If you select the Write Configuration File To LCS button you will be able to select a file from a location of your choice. Refer to illustration 43.
Illustration 46 g01348537
Speed governor applications
Know in advance how to safely shut off the engine during normal and emergency stop conditions. When power to the governor is shut off, this does not guarantee a shutdown; it depends on the final application. Safety needs to be the primary thought during this procedure.
Speed governor applications require the speed control loop is calibrated for load transients and steady state conditions. Use this procedure to derive the values of the speed control coefficients (reset, gain, and compensation) for a fixed engine speed.Gain will determine the speed that the control system responds to an error, when the speed reference is changed or the load changes. A value