TERMINAL 5361697 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Description Qty
A 8T-3207 Lifting Bracket 1
5P-8622 Shackle 1
1D-4615 Bolt (3/4 inch by 10 by 5 1/2 inch) 2
1B-4331 Nut (3/4 inch by 10) 2
5P-8248 Washer (3.5 mm by 36.5 mm) 4 Start By:
Separate the track. See the procedure in Disassembly and Assembly, "Track - Separate" in this module.
Remove the outer drive axle only. See the procedure in Disassembly and Assembly, "Axle - Remove and Install" in this module.
Rotate the final drive until the drain plug is at the bottom.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: The oil capacity of the final drive is 14 L (3.7 US gal).
Remove the drain plug from the final drive. Drain the oil from the final drive.
Illustration 1 g00619544
Adjust tool (A) until dimension (X) is equal to 145 mm (5.7 inch). Install the lower bracket as shown in Illustration 1.
Illustration 2 g00617868
Remove two bolts from the sprocket segments.
Personal injury or death can result from lifting a heavy assembly.The heavy assembly can fall if using an incorrect hoist to lift the load.Be sure the hoist has the correct capacity to lift a heavy assembly. Approximate weight of the assembly is given below.
Note: The final drive weighs 670 kg (1480 lb).
Install a hoist and tool (A) on final drive (4).
Illustration 3 g00622099Note: Do not remove two bolts (3).
Remove bolts (1) .
Remove two bolts (2).
Use tool (A) and the hoist to remove the final drive from the machine.
Remove the O-ring seal from the face of the final drive hub.