TERMINAL-SOLDER 6H3591 - Caterpillar

Install bearing (4) .
Illustration 7 g00372201
Install hub (5) .
Install bearing (6) .
Illustration 8 g00372203
Install nut (7). Tighten the nut to a torque of 540 N m (398 lb ft).
Illustration 9 g00372204
Install nut lock (8) .
Illustration 10 g00372472
Install ring (9) .
Illustration 11 g00372473
Install hub (10) and the dowel pins.
Illustration 12 g00372474
Install eight bolts (11). Tighten the bolts to a torque of 215 40 N m (159 30 lb ft).
Illustration 13 g00372746
Note: Install the seal so that the seal is flush with the finished surface on hub (12). In order to hold screws, center punch each screw in two places.
Install the seal in hub (12). Tighten the screws to a torque of 11 4 N m (8 3 lb ft). See Illustration 13.
Illustration 14 g00372475
Install hub (12) .
Illustration 15 g00427598
Illustration 16 g00372476
Install four shims (13) .Note: You may need to add more shims or you may need to remove some shims in order to attain the dimension that is measured in Step 20.
Illustration 17 g00372477
Install retainer (14) .
Illustration 18 g00372513
Install retainer nut (15). Tighten the nut to a torque of 815 N m to 950 N m (601 lb ft to 701 lb ft).
Measure the distance at Dimension (F). Dimension (F) should measure 108.50 0.91 mm (4.272 0.036 inch).
If Dimension (F) does not measure 108.50 0.91 mm (4.272 0.036 inch), you must add a shim or you must remove a shim. Repeat Steps 17 through 20 in order to attain Dimension (F) .Note: Use the least amount of shims. Do not use more than seven shims.
Clean the sealing surface of retainer (14). Apply NO.17430 Loctite Gasket Sealant (Blue) to outside of retainer (14) .
Illustration 19 g00372536
Install cap (16) with bolts (17) .Note: Make sure that the cap is installed with the check/fill plug in a vertical position.End By:
Install the track roller frame. Refer to Disassembly and Assembly, "Track Roller Frame - Install".
Install the track. Refer to Disassembly and Assembly, "Track - Remove".
Fill the final drive case with oil to the correct level. Refer to Operation and Manual for the correct capacity.