TERMINAL 7H1176 - Caterpillar

The front face of flywheel housing, both sides of flywheel housing gasket and rear face of cylinder block must be free of oil, fuel, water, gasket adhesive, assembly compounds, or any other foreign material at assembly. After the flywheel housing is installed, cut gasket even with pan rail.(1) Tighten flywheel housing bolts with the procedure that follows:a. Tighten bolts 1 through 19 in number sequence to a torque of ... 40 7 N m (30 5 lb ft)b. Tighten bolts 1 through 9 in number sequence to a torque of ... 135 15 N m (100 11 lb ft)c. Tighten bolts 10 through 19 in number sequence to a torque of ... 55 7 N m (40 5 lb ft)(2) Maximum permissible change from an exact vertical face (face runout) at 4 points (total indicator reading) ... 0.38 mm (.015 in)(3) Torque for plug (Put 5P3413 Pipe Sealant on the threads at assembly) ... 9.5 1.5 N m (80 13 lb in)