THREADED FLANG 0800875 - Caterpillar

To avoid possible machine damage, shift the propel transmission only when:1. The machine is stopped.2. The propel lever is at STOP.3. The engine is idling.4. The propel transmission release switch is depressed.
This lever selects one of three gear ratios for forward and reverse travel speeds.Shift Release Switch
This switch hydraulically releases the propel transmission when depressed, allowing the transmission to be shifted.Rotor Transmission Shift Lever
The rotor clutch must be disengaged to shift the rotor transmission.
Three rotor speeds are possible by using different combinations of the rotor transmission shift lever and the rotor axle speed range shift lever. See the chart under "Rotor Speeds".This lever selects the gear ratio (high or low) of the rotor transmission.Move the lever to H to select the highest speed range of the rotor transmission.Move the lever to N to place the rotor transmission in neutral.Move the lever to L to select the low speed range of the rotor transmission.Rotor Clutch Lever
Engage and disengage the rotor clutch only with the engine at low idle and with no load on the rotor.
This lever engages the rotor when pushed forward and disengages the rotor when the lever is pulled back.When work is performed on the rotor or in the area of the rotor, the rotor clutch lever can be locked in the disengaged position to insure there is no rotor movement.Rotor Speeds
Three rotor speeds are possible by using different combinations of the rotor transmission shift lever and the rotor axle speed range shift lever. Rotor Axle Speed Range Switch
The rotor clutch must be disengaged to change the speed range of the rotor axle.
This switch selects high or low speed range of the rotor axle.Rotor Hood Door Control
This lever raises (UP) or lowers (DOWN) the rotor door.Rotor Load Control Auto-Manual Switch
This switch selects automatic or manual load control. This switch should be at AUTO when the machine is working and at manual when work is to be performed on the machine with the engine idling.Rotor Load Control Speed Switch
This switch selects the maximum travel speed attainable for each range. At HIGH the maximum travel speed is 100%. At MEDIUM the travel speed is 55% and at LOW the travel speed is 30% of the maximum.Rotor Load Control Sensitivity Switch
This switch controls the sensitivity of the cutter load control. This switch should normally be set to the fourth mark toward MAX. (Midpoint).Automatic/manual Cutter Depth Selector
This switch selects automatic or manual control of the cutter depth.Manual Rotor Cutting Depth Controls
Move this switch toward the front of the machine to raise the rotor. Move the switch toward the rear of the machine to lower the rotor.Seat
The operator's seat provided with this machine is in compliance with the appropriate class of ISO 7096. Adjust the seat at the beginning of each shift or when changing operators.Adjust the seat to allow full travel of the pedals when the operator is seated against the seat back.Operator's Seat Adjustment
Hold down on seat height level lever (1) to release the seat height lock. Move the seat