TIE ROD 2167465 - Caterpillar

Active Events
The "Active Events" menu option shows a list of "Active Events". A description and level (1, 2, or 3) are shown for each "Active Event". With the event highlighted, press the "OK" button in order to view more information for the active event. Use the left arrow button or the right arrow button in order to move to the next active event.Logged Events
The "Logged Events" menu option shows the list of events and diagnostic codes that have been recorded. With the event highlighted, press the "OK" button in order to view more information for the event. Use the left arrow button or the right arrow button in order to move to the next logged event.Trigger Snapshot
The "Trigger Snapshot" menu option allows the user to initiate a snapshot of the system. This snapshot will be in addition to the snapshots that are already programmed. The snapshot will remain active until the time has elapsed.Snapshot Config
The "Snapshot Config" menu option allows the user to select a "Master Event Number" or "Event/Diagnostic" and when the selected event occurs the system will capture a "snapshot". Only one "Master Event" or "Event/Diagnostic" can be configured in this manner.Clear Snapshot Setting
The "Clear Snapshot Stg" menu option allows the user to clear the settings of the "snapshot".Data Logger Start/Stop
The "Data Logger Reset" menu option allows the user to reset the data logger. This option clears all of the logged information. Select the "Data Logger Reset" menu item. The Advisor shows the time that is available for the data logger on the right side of the screen. Thirty minutes will be available after the data logger has been reset.Note: The Advisor must be in the Service Mode in order to reset the data logger and to perform other service functions. Event Configuration
The "Event Configuration" menu option allows the user to set the configuration of the event according to the following parameters:
Log Event
Display Event
Broadcast Event
Enable Service Lamp
Factory DefaultPop-up Message Config
The "Pop-up Msg Config" menu option allows the user to set the configuration of the "Pop-up Message" according to the following parameters:
Parking Brake
Steer./Trans Lock
Implement Lockout Active
Transmission Lockout Active
Altitude Derate Active
Idle Elevated To Warm Eng.
Cold Pwr. Trn. Oil Eng. Spd Lmt
Red. Eng. Spd Shift Active
Delayed Shift Active
Top Gear Limited
Transmission Neutralized
Downshift Inhibit
LUC Disabled
Low Batt. Volt Elevated Idle
Engine Shutdown Switch On
Neutral Shift InhibitConditional Logger
The "Conditional Logger" menu option allows the user to "Enable" or "Disable" the Conditional Logger as well as to set the "Duration". The logger turns on automatically based on a machine condition of the transmission in FIRST FORWARD or FIRST REVERSE and engine speed is 1000 rpm.Calibrations
The "Calibrations" menu option is displayed under the "Service" menu. Once the "Calibrations" option is displayed on the "Service" menu, the user can access this function by pressing the "OK" button. The "Calibrations" option will allow calibrations.From the "Service" menu, use the appropriate arrow button to highlight the "Calibrations" option. Then press the "OK" button in order to access the "Calibrations" option. The "Calibrations" option includes the following list of available