parts catalog

TILT CYL 0614161 - Caterpillar

0614161 TILT CYL Caterpillar parts TILT
Alternative (cross code) number:
Caterpillar 0614161 TILT CYL

Buy TILT CYL 0614161 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Side view(s) of fuel transfer pump to show Piston Check Valve, Outlet Check Valve and Inlet Check Valve: Two 6I3185 Spacers replace two original 9X4628 Seals and one 8L2746 Seal replaces original 9X4628 Seal (at locations shown).Two new parts, 6I3185 Spacer and 8L2746 Seal, replace the original 9X4628 Seals used in the fuel transfer pump.Both the seal and the spacer feature a material design change to improve service life. The new parts are dimensionally the same as the original parts but can be identified by color: 6I3185 Spacer (new) ... White8L2746 Seal (new) ... Brown9X4628 Seal (original) ... BlackReference: Parts ManualReference: Service ManualDisassemble Fuel Transfer Pump
1. Remove connector (1) and O-ring seal (not shown). Remove connector (2) and O-ring seal (not shown). 2. Remove spring (3), valve (4) and 9X4628 Seal (not shown).
Cover (5) is under spring pressure. To prevent personal injury, carefully remove bolts (6) to release the spring pressure.
3. Remove, carefully, bolts (6), cover (5), 9X4628 Seal and spring (not shown). 4. Remove valve (7) and 9X4628 Seal (not shown).Assemble Fuel Transfer Pump With 6I3185 Spacers and 8L2746 Seal
1. Install 6I3185 Spacer (8), valve (7) and plate (9) into piston (10). 2. Install piston (10) and spring (11) into bore. Install 8L2746 seal into the bore that is to the right of the bore where piston (10) is installed. 3. Lubricate 3P1979 Seal (12) with clean diesel fuel and install into seal groove in cover (5).4. Position cover (5) over spring (13) and install bolts (not shown) through cover (5) into pump housing (14). Cover (5) is installed under spring (13) pressure. Push cover (5) down and turn bolts (not shown) evenly until cover (5) seats against pump housing (14). 5. Install 6I3185 Spacer (15) into pump housing (14) bore. 6. Install valve (4) and spring (13) into pump housing (14) bore. 7. Lubricate, with clean diesel fuel, and install O-ring seals (not shown).8. Install connectors (1) and (2) into pump housing (14).

Parts tilt Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.