TILT GP 0988412 - Caterpillar

Marking Procedure
Use a sheet of cardboard at the center of the bucket to create a profile.
Cut the cardboard to the existing profile of the bucket.
On the cardboard, draw a straight line (D) at angle (B). Measure a distance (A). The distance (A) should be perpendicular to the ground and up to line (D). The point of intersection (E) is the location for the bottom of the hook assembly.
Cut the cardboard along the line (D). This will create the existing profile of the bucket.Weights
Personal injury or death can result from improper lifting or blocking.When a hoist or jack is used to lift any part or component, stand clear of the area. Be sure the hoist or jack has the correct capacity to lift a component. Install blocks or stands before performance of any work under a heavy component.Approximate weights of the components are shown. Clean all surfaces where parts are to be installed.
Table 3
Weights    
Part Number     Part Name     Weight    
113-2677     Flat Hook    
68 kg (153 lb)    Use a suitable lifting device to lift the 113-2677 Flat Hook into the proper location in order to weld to the work tool.Installation of the 113-2677 Flat Hook
Personal injury or death can result from fumes, gases and ultraviolet rays from the weld arc.Welding can cause fumes, burn skin and produce ultraviolet rays.Keep your head out of the fumes. Use ventilation, exhaust at the arc, or both, to keep fumes and gases from your breathing area. Wear eye, ear and body protection before working.Protect yourself and others; read and understand this warning. Fumes and gases can be dangerous to your health. Ultraviolet rays from the weld arc can injure eyes and burn skin. Electric shock can cause death.Read and understand the manufacturer's instructions and your employer's safety practices. Do not touch live electrical parts.See "American National Standard Z49.1, Safety in Welding and Cutting" published by the American Welding Society.American Welding Society
2501 N.W. 7th Street
Miami, Florida 33125
See "OSHA Safety and Health Standards, 29 CFR 1910", available from U.S. Department of Labor.U.S. Department of Labor
Washington, D.C. 20210
Illustration 3 g00660928
(F) The width is 529 mm (21 inch). (G) These bars are used to ship the hook. The bars are also used to install the hook.
Do not remove the bars from the hook assemblies until the hook assemblies are completely welded to the work tool. Failure to keep the bars in place may lead to misalignment of the hooks and improper operation of the quick coupler.
Center the 113-2677 Flat Hook on the back of the work tool. Set a 600 mm (24 inch) or longer level in the pockets of the hooks in order to level the hook assembly on the work tool.
Tack weld the 113-2677 Flat Hook to the work tool. The weld must be sufficient. This allows the work tool to be lifted. The work tool can also be rotated.
Couple the work tool to the quick coupler in order to check the accuracy of the