TIP GP-ABRASION 3683864 - Caterpillar

Table 1
Failure Mode Identifiers    
FMI    Description of Failure    
00     "Data valid but above normal operating range"    
01     "Data valid but below normal operating range"    
02     "Data erratic, intermittent or incorrect"    
03     "Voltage above normal or shorted high"    
04     "Voltage below normal or shorted low"    
05     "Current below normal or open circuit"    
06     "Current above normal or grounded circuit"    
07     "Mechanical system not responding properly"    
08     "Abnormal frequency, pulse, or period"    
09     "Abnormal update"    
10     "Abnormal rate of change"    
11     "Failure mode not identifiable"    
12     "Bad device or component"    
13     "Out of calibration"    
14     "Not used"    
15     "Not used"    
16     "Parameter not available"    
17     "Module not responding"    
18     "Sensor supply fault"    
19     "Condition not met"    
20     "Not used"    When a diagnostic code is generated, an indicator on the engine is activated in order to alert the operator. If the condition that generated the code is momentary, the code may be cleared with the "Diagnostic Reset Switch". If the code remains on the display, the code is active. An active diagnostic code represents a problem with the electronic control system. Correct the problem as soon as possible.