AVSPARE.COM
parts catalog

TIP-PEN-PLUS 3895743 - Caterpillar


3895743 TIP-PEN-PLUS Caterpillar parts
Rating:
85
Alternative (cross code) number:
CA3895743
389-5743
3895743
Caterpillar 3895743 TIP-PEN-PLUS
Weight: 16 pounds 7 kg.

Buy TIP-PEN-PLUS 3895743 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:
  For full view, you need register

Information:


Table 1
Event Code    
Description    Conditions which Activate the Code    System Response    
E225 (3) Engine Overcrank     The engine did not start within the programmed parameters for starting.     The alarm output is activated. The code is logged.    Note: Refer to Troubleshooting, "Engine Monitoring System" for information on trip points and delay times.Probable Causes
The gas supply to the engine is insufficient.
A feature for engine protection prevents the engine from starting.
The starting motor circuit is faulty.
There is no engine speed signal to the Electronic Control Module (ECM).
The ignition system is not functioning.
The base timing is incorrect.
The quality of the gas does not match the parameter for "Fuel Quality".
Programmable parametersRecommended Repairs
Check the Gas Supply to the Engine
Check for low gas pressure. If the gas pressure is low, refer to Troubleshooting, "Fuel Pressure Problem".If the throttle does not open, check for binding of the throttle actuator. Move the throttle plate while you feel the motion. If the motion is sticky and/or rough, investigate the cause of the binding. Make the necessary repairs.Check for binding of the fuel metering valve. Move the plate while you feel the motion. If the motion is sticky and/or rough, investigate the cause of the binding. Make the necessary repairs.Check for Active Shutdowns
Use the Caterpillar Electronic Technician (ET) to check for active diagnostic codes or for event codes which may prevent the engine from starting.Correct the cause of the active code. Before the engine can be started, you must cycle the power to the engine. Set the engine control to the OFF/RESET mode. Then set the control to the STOP mode.Check the Status of the Relay for the Starting Motor
Attempt to start the engine while you observe the status of the relay for the starting motor on Cat ET.If the status of the relay for the starting motor indicates that the engine should crank but no cranking occurs, troubleshoot the starting circuit. Refer to Troubleshooting, "Starting - Test".If cranking occurs, check the engine rpm.Check the Engine Speed
The ECM must detect a minimum of 50 rpm before the gas and the ignition are supplied to the engine. Use Cat ET to monitor the engine speed while you crank the engine.If no engine speed is displayed on Cat ET or if the engine speed is not stable, troubleshoot the speed/timing sensor. Refer to Troubleshooting, "Speed/Timing - Test".Check for Diagnostic Codes
Check for active diagnostic codes that relate to the ignition system. If there is at least one active diagnostic code that relates to the ignition system, troubleshoot the diagnostic code.Check the Base Timing
Verify that the base timing is correct. Refer to Systems Operation/Testing and Adjusting, "Ignition Timing - Adjust".Check the Fuel Quality
Compare the Low Heat Value (LHV) of the gas supply to the "Fuel Quality" parameter that is programmed by the customer into the ECM. The ECM uses the setting for start-up and for air/fuel ratio control at low loads.If the LHV of the fuel does not match the "Fuel Quality" parameter that is programmed

Caterpillar SIS machinery equipment:

Caterpillar SIS
972M Wheel Loader L8E00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966M Wheel Loader R8D00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966M XE Wheel Loader B8P00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972M XE Wheel Loader M5S00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
320D2 Excavator XBA00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
318F L Excavator FFT00001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION
966M Wheel Loader LMM00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972M Wheel Loader GGN00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
320F L Excavator NHD00001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION
966M Wheel Loader EJA00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972M Wheel Loader LSJ00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
318F L Excavator HCP00001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION
972M Wheel Loader M8W00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966M Wheel Loader L8R00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966L Wheel Loader FSL00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972L Wheel Loader YJW00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
320D2 & 320D2 L Excavators ESG00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
966M Wheel Loader GMS00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966M XE Wheel Loader XCR00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972M Wheel Loader A7800001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972M XE Wheel Loader AN300001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966H Wheel Loader Military RWE00001-UP (MACHINE) POWERED BY C11 Engine » 389-5743 TIP-PENETRATION
966H Wheel Loader A6G00001-UP (MACHINE) POWERED BY C11 Engine » 389-5743 TIP-PENETRATION
972H Wheel Loader A7G00001-UP (MACHINE) POWERED BY C13 Engine » 389-5743 TIP-PENETRATION
320D Forest Machines BZF00001-UP (MACHINE) POWERED BY C6.4 Engine » 389-5743 TIP-PENETRATION
320D Log Loader GKS00001-UP (MACHINE) POWERED BY C6.4 Engine » 389-5743 TIP-PENETRATION
320D L & 320D LN Excavators GDP00001-UP (MACHINE) POWERED BY C6.4 Engine » 389-5743 TIP-PENETRATION
320D & 320D L Excavators KLM00001-UP (MACHINE) POWERED BY C6.4 Engine » 389-5743 TIP-PENETRATION
320E L Excavators TNJ00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
320E, 320E L & 320E LN Excavators DFG00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
320E LRR Excavator PNL00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
320E LRR Excavator TFX00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
320E & 320E L Excavators AWS00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
320E RR & 320E LRR Excavators LHN00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
320D Excavator JPD00001-UP (MACHINE) POWERED BY C6.4 Engine » 389-5743 TIP-PENETRATION
966K Wheel Loader PBG00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972K Wheel Loader PEM00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972M Wheel Loader A8P00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
972M Wheel Loader JPR00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966M Wheel Loader KJP00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
966H Wheel Loader BS600001-UP (MACHINE) POWERED BY C11 Engine » 389-5743 TIP-PENETRATION
318E L Excavator WZS00001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION
318E L Excavator DZF00001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION
320D2 & 320D2 L Excavators DNP00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
972M XE Wheel Loader EDW00001-UP (MACHINE) POWERED BY C9.3 Engine » 389-5743 TIP-PENETRATION
M320D2 Wheeled Excavator CH900001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
M318D Wheeled Excavator P8L00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
M318D MH Wheeled Excavator P9M00001-UP (MACHINE) POWERED BY C6.6 Engine » 389-5743 TIP-PENETRATION
M320F Wheeled Excavator F2W00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
M318F Wheeled Excavator F8B00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
M316F Wheeled Excavator F6N00001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION
M320D2 Wheeled Excavator EN800001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
320D2 & 320D2 L Excavators RDZ00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
320F L Excavator YBM00001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION
320D2 & 320D2 L Excavator DNS00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
320D2 & 320D2 L Excavators ZBD00001-UP (MACHINE) POWERED BY C7.1 Engine » 389-5743 TIP-PENETRATION
M317D2 Wheeled Excavator CA600001-UP (MACHINE) POWERED BY C4.4 Engine » 389-5743 TIP-PENETRATION


Parts tip Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.