TIP-HARD 3S0459 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Check all gaskets and O-rings for wear or damage. Replace these components, if necessary.
Drain the water from the system.
Illustration 1 g00588663
Remove four bolts (1).
Remove the bolt (3) and the retainer. Remove the two clips (2).
Remove the elbow (4).
Remove the tube (5).
Illustration 2 g00588665
Remove ten bolts (6).
Remove the elbow (7) and the gasket.
Illustration 3 g00606353
This is an Illustration of a typical arrangement.
Remove the bolt or the bolts (9). Remove the retainers.
Remove the tube (8).
Remove ten bolts (10).
Remove the elbow (11) and the gasket. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Lubricate all the seals with glycerin before installation.
Illustration 4 g00606353
This is an Illustration of a typical installation.
Replace the elbow (11) and the gasket.
Replace ten bolts (10).
Replace the tube (8).
Replace the bolt or the bolts (9). Replace the retainers.
Illustration 5 g00588665
Replace the elbow (7) and the gasket.
Replace ten bolts (6).
Illustration 6 g00588663
Replace the tube (5).
Replace the elbow (4).
Replace the bolt (3) and the retainer. Replace the two clips (2).
Replace four bolts (1).
Fill the water system to the correct level. Check the Operation And Maintenance Manual for the correct procedure.