TIP-RIPPER 4T5501 - Caterpillar

Removal Procedure
Disconnect batteries before performance of any service work.
Note: Before disconnecting the harness assemblies and cable assemblies, mark the items for the proper connections in order to ensure correct assembly.
Illustration 1 g01382950
Disconnect the harness assemblies and cable assemblies from solenoids (1) and electric starting motors (2).
If the engine has two electric starting motors, disconnect the harness assemblies between two solenoids (1) and starting motors (2).
Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor (2) is approximately 36 kg (79 lb).
Remove three bolts (3). Remove electric starting motor (2). Remove the gasket from the joint between the electric starting motor and the flywheel housing. Installation Procedure
Inspect the gasket for the joint between the starting motor and the flywheel housing. Obtain a new gasket, if necessary.
Attach a suitable lifting device to the electric starting motor. The weight of electric starting motor (2) is approximately 36 kg (79 lb).
Illustration 2 g01382950
Place the gasket in the cover for electric starting motor (2). Lift electric starting motor (2) onto the mounting position. Install three bolts (3).
Connect the harness assemblies and cable assemblies to solenoids (1) and electric starting motors (2).
If the engine has two electric starting motors, connect the harness assemblies between the two solenoids and electric starting motors (2).