TIP GP-PENETRATION PLUS 5054097 - Caterpillar

Install Cylinder Head Assembly (3306)
1. Thoroughly clean the spacer plate and the bottom surface of the cylinder head that make contact with the cylinder head gasket. Be sure a new gasket has been installed between spacer plate and cylinder block. See INSTALL SPACER PLATE.2. Install cylinder head gasket (1).3. Fasten a hoist and install the cylinder head assembly (2) on the cylinder block.
Make sure the dowels in the rocker shaft assembly are in alignment with the holes in the cylinder head before the bolts are installed and tightened.
4. Install the push rods and put rocker shaft (3) in position on the cylinder head. Put 2P2506 Anti-Seize Compound on the threads of the cylinder head and rocker shaft bolts. Install the bolts and washers and tighten the bolts as follows: 1. Tighten all bolts in number sequence to a torque of 115 lb.ft. (156 N m).2. Again tighten all bolts in number sequence to a torque of 185 13 lb.ft. (250 17 N m).3. Again tighten all bolts in number sequence (hand torque only) to a torque of 185 13 lb.ft. (250 17 N m).4. Tighten all bolts in letter sequence to a torque of 22 lb.ft. (30 N m).5. Again tighten all bolts in letter sequence to a torque of 32 5 lb.ft. (43 7 N m).6. Again tighten all bolts in letter sequence to a torque of 32 5 lb.ft. (43 7 N m). 5. Make adjustment of valves to have a clearance of .015 in. (0.38 mm) for intake and .025 in. (0.64 mm) for exhaust. See VALVE CLEARANCE SETTING in TESTING AND ADJUSTING.6. Install bracket (4) and the bolts which hold it to the cylinder head.7. Put gaskets (6) and (7) in position. Put elbow (5) in position and install the bolts. Tighten hose clamp (8).end by:a) install water temperature regulatorb) install exhaust manifoldc) install carburetord) install air cleanere) install valve cover