TIP AS- 5054102 - Caterpillar

Disassembly Procedure
Start By:
Remove the joystick control and mounting. Refer to Disassembly and Assembly, "Pilot Operated Hydraulic Control - Remove".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00785015
Remove the grommet and wire (1) from the work tool control and mounting assembly.
Loosen nut (2) and twist off handle (3) from the work tool control and mounting assembly.
Illustration 2 g00591130
Remove boot (4) from the handle.
Illustration 3 g00785025
Remove pin (5) from the handle.
Remove lever kit (6) from the handle.
Illustration 4 g00785035
Remove allen head screw (7) and coil assembly (8) .
Illustration 5 g00785038
Remove solenoid (9) .
Repeat Steps 1 through 7 for the opposite side.