TIP GP-LONG 9J3169 - Caterpillar

TYPE="TABLE" @@@-->
Engine exhaust contains products of combustion which may be harmful to your health. Always start and operate the engine in a well ventilated area and, if in an enclosed area, vent the exhaust to the outside.
Note: The crank cycle and the number of crank cycles are programmable. The crank cycle is the amount of time for engagement of the starting motor. This also includes the amount of time for cooling of the starting motor between crank cycles. If the engine does not start within the number of crank cycles that are programmed, the fuel system is disabled. The "OVERCRANK" indicator will illuminate in order to warn the operator of an overcrank.Automatic Starting
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode.
The position for the engine control switch depends on the type of control panel. The engine control switch must be in the "AUTO" position for the EMCP II and the EMCP II+ control panel. For the Switchgear Conversion control panel, the engine control switch must be in the "REMOTE" position.The engine will automatically start when the remote start/stop initiate contact closes.Manual Starting
For initial start-up of a new or rebuilt engine, and for start-up of an engine that has been serviced, make provision to shut the engine off should an overspeed occur. This may be accomplished by shutting off the air and/or fuel supply to the engine.
Do not start the engine or move any of the controls if there is a "DO NOT OPERATE" warning tag or a similar warning tag attached to the start switch or to the controls.Ensure that no one will be endangered before the engine is started and when the engine is started.
Perform all of the procedures that are described in this Operation and Maintenance Manual (Operation Section), "Before Starting Engine".
Do not engage the starting motor when flywheel is turning. Do not start the engine under load.If the engine fails to start within 30 seconds, release the starter switch or button and wait two minutes to allow the starting motor to cool before attempting to start the engine again.
Illustration 1 g00319402
Engine control switch in the "MAN. START" positionThis engine control switch is used for the EMCP II and for the EMCP II+ control panel.
To start an engine with the EMCP II or the EMCP II+ control panel, turn the engine control switch to the "MAN. START" position.