TIP-PENETRATION 9W8309 - Caterpillar

Engines:
3606 (S/N: 8RB)
3608 (S/N: 6MC)
3612 (S/N: 9RC, 9FR, 2NZ)
3616 (S/N: 1PD, 1FN)
3618 (S/N: 2MW)
G3606 (S/N: 3XF)
G3608 (S/N: 4WF)
G3612 (S/N: 1YG)
G3616 (S/N: 4CG)
New heavy-duty water pump seal assemblies are available for these engines. The new seal assemblies can be used as service replacements for engines in the field. The new heavy-duty seals are more compatible with the following liquids: poor quality coolant, sea water and river water. The new seal assemblies are more resistant to engine vibration. In addition, the new seals are more tolerant of rough installation. The new seal assemblies will provide increased service life.The part numbers for the new seal assemblies are listed in Table 1.Note: In order to install the new heavy-duty seals on current water pumps, modifications must be made to the water pump shaft. The modification procedure is listed below.
Table 1
New Seal Assemblies and Related Parts    
New Seal Assembly Part No.     Application     Water Pump Part No.     Pump Shaft Part No.    
189-0609     Auxiliary Sea Water Pump     7E-4358
130-0475
130-0477     170-6676    
189-0610     Jacket Water Pump or Aftercooler/Oil Cooler Pump     7E-3172
7E-8179     170-6678    Note: The carbon seals will continue to be used for production engines.Modification Procedure
Refer to the appropriate Disassembly and Assembly Manual. Remove the water pump from the engine.
Disassemble the water pump.
Illustration 1 g00691979
This illustration shows the location of the drill points (V) on the shaft. View A-A is shown in Illustration 2. Dimension (B) is 150.73 0.38 mm (5.934 0.015 inch) for the 170-6676 Shaft. Dimension (B) is 127.21 0.38 mm (5.008 0.015 inch) for the 170-6678 Shaft .
Illustration 2 g00691990
This illustration shows View A-A of the shaft. The holes (V) must be equally spaced around the circumference of the shaft (120 degrees apart). The holes should be 5.5 0.5 mm (0.22 0.02 inch) in diameter. The holes should be 1.0 0.5 mm (0.04 0.02 inch) deep.
Refer to Illustrations 1 and 2. Machine the three drill points in the shaft. These drill points will be used to locate the set screws for the new seal assembly.
After machining the shaft, remove all burrs and sharp edges from the shaft.Note: An O-ring must slide over the drill points. The surface finish of the shaft must be smooth. The surface must also be free from nicks and grooves.
Begin assembly of the water pump. To install the seal, follow Steps 6 through 14.
Use a dial indicator to check the end play of the shaft. The shaft end play must not exceed 0.12 mm (0.005 inch).
Illustration 3 g00691995
This is a view of the seal assembly. Dimension (C) is 42.4 mm (1.67 inch) for the 189-0609 Seal Assembly. Dimension (C) is 43.9 mm (1.73 inch) for the 189-0610 Seal Assembly . (S) Set screw (X) Rotating Seal (Z) Stationary Seal Ring
A container of silicone lubricant is supplied with the seal assembly. Use a small amount of silicone lubricant to lubricate the following components: the O-ring on the stationary seal