AVSPARE.COM
parts catalog

TIRE, TUBE & WHEEL ASSEMBLY 0004334 - Caterpillar



0004334 TIRE, TUBE & WHEEL ASSEMBLY Caterpillar parts WE-601B TIRE
Rating:
11
Alternative (cross code) number:
CA0004334
000-4334
0004334
Caterpillar 0004334 TIRE, TUBE & WHEEL ASSEMBLY

Buy TIRE, TUBE & WHEEL ASSEMBLY 0004334 Caterpillar genuine, new aftermarket tractor parts with delivery
WINDROW ELEVATOR,

Compatible equipment models: 0004334:

WINDROW ELEVATOR  WE-601B   Caterpillar
Number on catalog scheme:
 
  For full view, you need register

Information:


Illustration 1 g01379685
Place the key start switch and the disconnect switch in the OFF position.
Take the following measurement at the Connector for the Right or Left Hand laser/sonic harness. Measure the resistance between contact C (wire L854-YL) and contact D (wire L855-GN).Expected Result:The resistance measurement is 60 6 ohms.Results:
YES - The resistance measurement is 60 6 ohms. Proceed to Test Step 5.
NO - The resistance measurement is NOT 60 6 ohms. Proceed to Test Step 3.Test Step 3. CHECK THE CAN TERMINATION RESISTORS.
Place the key start switch and the disconnect switch in the OFF position.
Disconnect the 3-pin connector for all four of the termination resistors.
Measure the resistance between contact A (wire L854-YL) and contact B (wire L855-GN) for all of the resistors. Note the resistance.Expected Result:The resistance measurement is 120 12 ohms.Results:
YES - The resistance measurement is 120 12 ohms. Reconnect the resistors. Proceed to Test Step 5.
NO - One or all resistance measurements is NOT 120 12 ohms. Repair: Replace the termination resistor(s) that did not measure 120 12 ohms.STOPTest Step 4. CHECK THE HIGH CIRCUIT OF THE CAN DATA LINK FOR SHORTS
Move the "Power/Setup"Switch on the display to the "OFF" position.
Turn the key start switch and the disconnect switch for the machine to the "OFF" position.
Disconnect all of the sensors that are connected to the harness.
Laser Receivers
Angle Sensors
Rotation Sensor
Illustration 2 g01189993
Take the following measurements at the Connector on the Left or the Right Knuckle. Measure the resistance between the contacts that are listed in Table 1.
Table 1
Harness Connector at Angle Sensor    
Check from Pin C to Pin A    
Check from Pin C to Pin B    
Check from Pin C to Pin

Caterpillar parts catalog:

Caterpillar parts catalog
WE-601B WINDROW ELEVATOR 7EC00168-UP (MACHINE)


Parts tire Caterpillar catalog:

1319160 TIRE & TUBE GP
525, 533, 543, HA770, HA771, HA870, HA871, TK370, TK371, TK380, TK381
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.