TOOL-SWAGE 1428278 - Caterpillar

(5T7155 Shown)5T7155 (12G, 130G, 140G)
(1) Torque for 38 nuts ... 300 15 N m (220 11 lb ft) Lubricate washer faces and stud threads with 2P2506 Thread Lubricant before assembly. Hand check torque for nuts 100%(2) Torque for studs (in case) ... 149 20 N m (110 15 lb ft)(3) Torque for bolts ... 55 7 N m (41 5 lb ft)(4) Torque for bolts ... 270 15 N m (200 11 lb ft)(5) Apply 5P0960 Multipurpose Grease to the washers and rings surface.(6) Press seal flush with end of housing.(7) Adjust shim pack thickness to provide end play of ... 0.00 to 0.06 mm (.000 to .002 in)(8) Install retainer with bevel toward sprocket as shown.Bearing Adjustment Procedure:
The procedure that follows must be used to put the correct amount of preload on the bearings for the final drive:1. Rotate shaft (9) and hit (strike) the hub of sprockets (10) while tightening nut (11) with spanner wrench.2. Tighten nut (11) until a torque of 11.30 1.13 N m (100.570 10.057 lb in) above seal drag is required to rotate shaft.3. Back off nut (11) one locking position and hit (strike) the hub of sprockets (10) again.4. Final torque to rotate shaft (9) should be 3.95 1.13 N m (35.155 10.057 lb in) above seal drag.5T7156 (120G)
(1) Torque for 40 nuts ... 170 15 N m (125 11 lb ft) Lubricate washer faces and stud threads with 2P2506 Thread Lubricant before assembly. Hand check torque for nuts 100%(2) Torque for studs (in case) ... 100 14 N m (75 10 lb ft)(3) Torque for bolts ... 55 7 N m (41 5 lb ft)(4) Torque for bolts ... 135 15 N m (100 11 lb ft)(5) Apply 5P0960 Multipurpose Type Grease to the washers and rings surface.(6) Press seal flush with end of housing.(7) Adjust shim pack thickness to provide end play of ... 0.06 to 0.10 mm (.002 to .004 in)(8) Install retainer with part number toward the sprocket.Bearing Adjustment Procedure:
The procedure that follows must be used to put the correct amount of preload on the bearings for the final drive:1. Rotate shaft (9) and hit (strike) the hub of sprockets (10) while tightening nut (11) with spanner wrench.2. Tighten nut (11) until a torque of 7.91 1.13 N m (70.399 10.057 lb in) above seal drag is required to rotate shaft.3. Back off nut (11) one locking position and hit (strike) the hub of sprockets (10) again.4. Final torque to rotate shaft (9) should be 2.26 1.13 N m (20.114 10.057 lb in) above seal drag.