TOOL GP-HAND 1455692 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 439-3938 Link Bracket 2
B 221-8647 Seal Installer Gp 1
C 8S-1592 Socket 1
D 1S-0258 Plastic Hammer As 1
E FT-3303 Driver 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install the vent valve by using Tooling in different types.
Illustration 1 g06123215
Use Tooling (C) and (D) to install vent valve (8), if the vent valve driven from the top down.
Illustration 2 g06123227
Use Tooling (D) and (E) to install vent valve (8), if the vent valve driven from the bottom up.
Illustration 3 g00911612
Use Tooling (B) to install the seals.
Illustration 4 g00602328
Ensure that the lip of the seal is inside the housing.
If the water temperature regulator is installed incorrectly, it will cause the engine to overheat.
Illustration 5 g06123214
Install seals (6). Install gasket (5) and water temperature regulators (7).
Illustration 6 g00602197
Use Tooling (A) and a suitable lifting device to position water temperature regulator housing (4) on the engine. Install bolts (3).
Illustration 7 g00602196
Connect tube assemblies (2) to the water temperature regulator housing.
Illustration 8 g00602193
Connect tube assembly (1) to the water temperature regulator housing.
Fill the cooling with coolant to the correct level. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".