TOOL GP-HAND 2548163 - Caterpillar

Install bolt (1), washer (2), and cap (3) to hold the staking tool together as a unit.Note: Install the bolt finger tight.
Install the proper sleeve bearing (F) over diameter (A) or (B), depending on housing style. The sleeve bearing should be seated against the shoulder of guide (6) .
When positioning the pump/motor housing (E) in a hydraulic press, make sure it is level. If the sleeve bearing bore is not aligned correctly, the housing and/or the sleeve bearing can be damaged beyond repair when the sleeve bearing is pressed into the housing.
Carefully position the pump or motor housing in a hydraulic press capable of attaining 4.5 t (5 tons) of force.
Place the staking tool and sleeve bearing (F) on housing (E) and align the sleeve bearing to the housing bore.
When positioning tooling on housing (E) make sure staking legs (5) are in alignment with staking grooves (10) in the housing. If they are not aligned, the housing will be damaged.
Illustration 6 g02588337
(11) Bore of Housing (Bottom View, Looking Up). (5) Staking Legs. (10) Staking Grooves. (C) Staking legs correctly aligned. (D) Staking legs not aligned.
Remove bolt (1) and washer (2) from the top of the staking tool guide stem.
Use hydraulic press (12) to push the staking tool and sleeve bearing (F) into the housing bore just until sleeve (7) contacts the surface of pump or motor housing (E). Do not apply more force than is required.Note: The hydraulic press must not contact the upper guide stem during this step. The guide stem should be recessed in the cap, as shown.
Illustration 7 g02588364
(7) Sleeve. (12) Hydraulic Press. (E) Pump or Motor Housing.
Retract the hydraulic press. Remove the cap from the staking tool. Extend the hydraulic press to contact the upper guide stem end of driver (8) .
Illustration 8 g02588367
(7) Sleeve. (8) Driver. (12) Hydraulic Press. (E) Pump or Motor Housing.
Use the hydraulic press to push driver (8) down until the hydraulic press is even with the top surface of sleeve (7). Do not apply more force than is required. Sleeve bearing (6) is now staked (G) into pump or motor housing (E) .
Illustration 9 g02588376
(6) Sleeve Bearing. (7) Sleeve. (8) Driver. (E) Pump or Motor Housing. (G) Stake.
Retract the hydraulic press. Place cap (3) on the staking tool. Install bolt (1) and washer (2) through cap and thread into upper guide stem. Use a wrench to tighten the bolt until driver (8) releases the pressure on the staking legs.
Use of air powered or impact tools can damage the threads of the bolt and/or upper guide stem. Only use a hand wrench when tightening the bolt to release pressure on the staking legs.
Illustration 10 g02588396
(1) Bolt. (2) Washer. (3) Cap. (8) Driver.
Carefully remove the staking tool from the sleeve bearing. Some twisting or back and forth motion may be required to remove the staking tool.
Inspect the pump or motor housing to make sure sleeve bearing staking (G) is complete and properly located within the housing bore.
Illustration 11 g02588398
(G) Sleeve Bearing Stakes.
Make sure sleeve bearing (H) is