TOOL-LONG MOIL POINT 3734918 - Caterpillar

Removal Procedure
Start By:
Install the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks (Front and Rear) - Remove and Install".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hot oil or hot components.At operating temperature, oil is hot and under pressure. Hot oil can cause burns.Remove the fill cap only when the engine is stopped, and the fill cap is cool enough to touch with your bare hand.Do not allow hot oil or components to contact skin.
Drain the engine oil into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".
Illustration 1 g01699873
Remove bolts (1). Remove tube assembly (2).
Illustration 2 g01699993
Remove O-ring seal (3).
Illustration 3 g01700013
Illustration 4 g01700179
Remove suction screen (4).
Illustration 5 g01700181
Remove bolt (5), screen (6), and O-ring seals (7). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Inspect the O-ring seals. Replace the O-ring seals that are worn or damaged.Note: Lubricate the O-ring seals lightly with the lubricant that is being sealed.
Illustration 6 g01700181
Install O-ring seals (7), screen (6), and bolt (5).
Illustration 7 g01700013
Illustration 8 g01700179
Install suction screen (4).
Illustration 9 g01699993
Install O-ring seal (3).
Illustration 10 g01699873
Install tube assembly (2). Install bolts (1).
Refill the engine oil. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change". End By:
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks (Front and Rear) - Remove and Install".