TOOL GP 5092877 - Caterpillar

Illustration 6 g01624676
(S/N: DXC1-UpRXS1-UpPCR1-Up)Tooling (C) is used for the removal and installation of bearings (1) and (4) . (2) Apply Tooling (D) to the threads of the bolt. Torque for the bolt ... 1800 200 N m (1330 150 lb ft) (3) Apply Tooling (D) to the threads of the head. Torque for the head ... 600 130 N m (440 95 lb ft) (5) Before assembly, apply Tooling (E) to the wiper seal groove. (6) Lubricate the sealing lips with the fluid that is being sealed.
Illustration 7 g01624678
(S/N: HXB1-UpSXB1-Up)Tooling (C) is used for the removal and installation of bearings (1) and (4) . (2) Apply Tooling (D) to the threads of the bolt. Torque for the bolt ... 900 100 N m (665 75 lb ft) (3) Apply Tooling (D) to the threads of the head. Torque for the head ... 600 130 N m (440 95 lb ft) (5) Before assembly, apply Tooling (E) to the wiper seal groove. (6) Lubricate the sealing lips with the fluid that is being sealed.Installation Procedure
Table 3
Required Tools    
Tool    Part Number    Part Description    Qty    
A     8S-7641     Tube     1    
4C-6486 Stand     1    
8S-8048 Saddle     1    
8S-7615 Pin     1    
B     1P-1863     Retaining Ring Pliers     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 8 g01624673
Illustration 9 g01624723
Attach a suitable lifting device to lift cylinder (6). The weight of lift cylinder (6) is approximately 57 kg (125 lb).
Use Tooling (B) in order to install retaining rings (5), (9), and (10). Position lift cylinder (6). Install washer (8) and retaining ring (9)