TOOL AS 5331183 - Caterpillar

Illustration 3 g01338945
Apply Tooling (F) to the threads of bolts (19).Install and tighten bolts (19) to a torque of 250 25 N m (184 18 lb ft) and turn an addition angle of 45 5 degrees.
Refer to Service Magazine, M0083843, "An Improved Bolts Tightening Procedure for the Critical Joints Is Now Used on All Excavators" for more detail information.
Illustration 4 g01338943
Install clip (18). Connect harness assembly (17).
Illustration 5 g01341624
Typical Example
Install Tooling (A) onto the hydraulic tank . Attach an air supply hose onto Tooling (A). Apply 276 414 kPa (40 60 psi). This procedure will pull a vacuum on the hydraulic system.
Illustration 6 g01338942
Connect hose assemblies (16). Temporarily disconnect the electronic control module (2).
Illustration 7 g01339214
Install bracket (14).
Illustration 8 g01339157
Install bolts (13).
Illustration 9 g01339155
Install bolt (12).
Illustration 10 g01339153
Install bolts (11).
Illustration 11 g01339141
Install panel (10).
Illustration 12 g01339139
Position the accumulator. Connect clamps (8). Connect hose (7). Install hoses (9).
Illustration 13 g01339137
Install panel (6). Install filter (5) .
Illustration 14 g01339134
Install bolts (4).
Illustration 15 g01339132
Position the ground wires. Install bolt (3) .
Illustration 16 g01339125
Install electronic control module (2).
Illustration 17 g01339124
Install guards (1).