TOOL AS 5584574 - Caterpillar

Illustration 1 g01347490
(1) Adapter assembly (2) Drive gear (3) Idler gear assembly (4) Pump adapter (5) Crankshaft gear
Illustration 2 g01347492
(A) Install the bearing joint at the following angle. ... 37.5 1.0 degreesNote: Measure angle (A) from the centerline of the two bolts of the adapter housing.Note: The relief in the bearing must line up with the relief in the gear within 2 degrees. The bearing must not extend beyond either face of the gear.
Illustration 3 g01347494
(C) Install the bearing joint at the following angle. ... 15 1 degreesNote: Measure angle (B) from the vertical center line of the adapter housing.
Illustration 4 g01347495
Section B-B (D) Outside diameter of the sleeve bearing before installation ... 69.952 0.020 mm (2.7540 0.0008 inch) (E) Distance from the end of the sleeve bearing to the edge of the adapter housing ... 3.5 0.5 mm (0.14 0.02 inch)