TOOL-SEAL INST 5634351 - Caterpillar

Installation Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Illustration 1 g01176552
Position swivel (4) and Install bolts (6) .
Illustration 2 g01176565
Connect hose assemblies (5) onto the bottom of swivel (4) .
Illustration 3 g01176561
Connect hose assemblies (3) onto the top of swivel (4) .
Illustration 4 g01176554
Reposition hose assemblies (2) .
Illustration 5 g01176558
Install plates (1) .End By: Install the undercarriage cylinder. Refer to Disassembly and Assembly, "Undercarraige Cylinder (Adjustable Gauge) - Install".