TOOL-INDEX 5634355 - Caterpillar

Illustration 1 g01177554
Remove bolt (1) .
Illustration 2 g01177556
Remove nuts (2), bolts (4), and muffler assembly (3) .
Illustration 3 g01177557
Remove bolts (5) and (7). Remove housing (6) .
Illustration 4 g01179027
Remove screws (8) and coupler assembly (9) .
Illustration 5 g01179032
Use Tooling (B) to remove retaining ring (10) and coupler (11) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-1859     Retaining Ring Pliers     1    
B     4C-5598     High Temperature Anti-Seize     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 6 g01179032
Install coupler (11). Use Tooling (A) to install retaining ring (10) .
Illustration 7 g01179027
Position coupler assembly (9) and install screws (8) .
Illustration 8 g01177557
Position housing (6). Install bolts (7). Tighten bolts (5) to a torque of 75 N m (55 lb ft).
Illustration 9 g01177556
Position muffler assembly (3). Install bolts (4). Apply Tooling (B) to the studs. Tighten nuts (2) to a torque of 12.5 N m (111 lb in).
Illustration 10 g01177554
Install bolt (1) .End By: Install the engine. Refer to Disassembly and Assembly, "Engine - Install".