TOOL G STOPPER 5P7392 - Caterpillar

1. Remove bolts (1) and washers from right side door (2). Open the door. 2. Loosen bolt (3) that holds the alternator to bracket (4).3. Loosen bolt (6) that holds the alternator to the mounting bracket.4. Move the alternator toward the engine in order to release the tension on V-belts (5).5. Remove the V-belts from the alternator drive pulley. 6. Disconnect wire assemblies (7), (8) and (9) from the alternator.7. Remove bolt (3) and two washers from bracket (4).8. Remove bolt (6), the nut and the washer from the alternator and the mounting bracket.9. Remove the alternator from the mounting bracket. Use a suitable puller in order to remove the pulley from the alternator.Install Alternator
1. Install the drive pulley to the alternator. Tighten the nut holding the pulley to the alternator to a torque of 102 7 N m (75 5 lb ft). 2. Position the alternator to the mounting bracket. Install bolt (6), the nut and the washer in order to secure the alternator to the bracket.3. Install V-belts (5) on the alternator pulley.4. Install bolt (3) and washer in order to hold the alternator to bracket (4).5. Refer to the "Operation & Maintenance Manual" for the proper procedure of adjusting V-belt tension. Adjust the V-belt tension. 6. Connect wire assemblies (7), (8) and (9) to the alternator.7. Install the boot over the terminal of wire assembly (9). 8. Close door (2). Install bolts (1) and washers in order to secure the door shut.