TOOL AR 6V3180 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7574 Link Bracket 2
A 9S-3263 Thread Lock Compound 1 Note: Check all of the O-ring seals and the components for wear or for damage. Replace the components, if necessary. Lubricate all of the O-ring seals lightly with the lubricant that is being sealed. Clean all of the components with a cloth that is free of loose material (lint).
Illustration 1 g00648595
Install O-ring seal (9) on the rear spindle assembly.
Illustration 2 g00696941
Attach Tooling (A) to brake housing assembly (7), as shown. Position a suitable lifting device on Tooling (A). Secure the suitable lifting device to a hoist. Lift brake housing assembly (7) into position, as shown. The weight of the brake housing assembly is approximately 630 kg (1390 lb).
Apply Tooling (B) to the studs on brake housing assembly (7).
Install full nuts (8) and the washers. Tighten the full nuts to a torque of 1150 150 N m (848 111 lb ft).
Remove Tooling (A) and install two bolts (10). Tighten the bolts to a torque of 310 25 N m (229 18 lb ft).
Illustration 3 g00648593
Connect tube assembly (5) and tube assembly (6).
Illustration 4 g00648592
Connect tube assembly (4).
Illustration 5 g00648589
Connect tube assembly (3).
Install nipple assembly (2) and dust cap (1).
Fill the hoist, torque converter, and brake tank to the correct level. Refer to Operation and Maintenance Manual, "Hoist, Torque Converter and Brake Tank Oil - Change". The capacity of the tank is 250 L (66 US gal).
Purge the air from the brake system. Refer to Air System and Brakes System Operation, Testing and Adjusting, "Brake System Air - Purge". End By:
Install the rear wheel, bearing, and the Duo-Cone seal. Refer to Disassembly and Assembly, "Rear Wheel, Bearing and Duo-Cone Seal - Install" for the Power Train.