TOOTH- 5332587 - Caterpillar

Illustration 6 g01363384
(10) Pipe Nipple
(11) Hose
(12) Drain plug
Install a pipe nipple (10) with hose (11) into the hole on the bottom of the hydraulic tank.
Loosen drain plug (12) in order to drain the oil.
Drain the oil into a suitable container.
After the oil has been drained, tighten drain plug (12) to 110 15 N m (81 11 lb ft).
Remove Pipe Nipple (10) and hose (11).
Clean plug (9) and install the plug. Tighten the plug to 75 5 N m (55 5 lb ft).
Open the access door on the right side of the machine.
Clean the pump, the hydraulic lines, and the hydraulic tank.
Illustration 7 g01363413
Remove the plug from the tube. Allow the oil to drain into a container.Note: Dispose of used filters and used fluids according to local regulations.
Inspect the O-ring. Replace the O-ring if wear or damage is evident.
Clean the plug. Install the plug and the O-ring into the drain port.
Illustration 8 g01363629
(13) Bolts
(14) Washers
(4) Cover for screen
(15) Spring
(16) Screen
Remove bolts (13), washers (14) and cover (4).Note: Dispose of used filters and used fluids according to local regulations.Note: Do not allow spring (15) to fall back into the tank.
Remove spring (15) and screen (16).Note: Refer to Operation and Maintenance, "General Hazard Information" for information on containing fluid spillage.
Wash the screen (16) in a clean nonflammable solvent. Allow the screen to dry. Inspect the screen. Replace the screen, if the screen is damaged.
Illustration 9 g01363676
(17) O-ring seal
(18) O-ring seal
Remove O-ring seal (17) from the screen.
Inspect O-ring seals (17) and (18). Replace the O-ring seals if wear or damage is evident.
Install O-ring seal (17) on screen (16).
Install screen (16) and spring (15). Then install cover (4), washers (14), and bolts (13).Note: Make sure that the O-ring seals and the spring are properly positioned during installation.
Fill the hydraulic system oil tank. Refer to Operation and Maintenance Manual, "Capacities (Refill)".
Illustration 10 g01363713
Inspect the O-ring seal on the filler plug for damage. Replace the O-ring, if necessary. Clean the filler plug. Install the filler plug.
Illustration 11 g01363717
Inspect the breather. Clean the breather.
Illustration 12 g01363722
(19) Seal
(20) Connector
(21) Drain hoseNote: Make no attempt to start the engine until the pump has been filled with hydraulic oil. Serious damage to the hydraulic components can result.
When the hydraulic oil has been replaced, the air must be removed from the hydraulic oil system. To remove the air from the hydraulic oil system, follow Step 28.a through Step 28.g.
While the engine is stopped, remove drain hose (21), connector (20) and seal (19) from the top of the pump. Add hydraulic oil through the opening.
Check the condition of seal (19). If the seal is damaged, replace the seal.
After the pump has been filled with oil, install drain hose (21), connector (20) and seal (19) to the original locations.
Start the engine. When the engine is at low idle, fully raise the boom. Hold the boom in this position.
Slowly loosen the drain hose (21) until the air has been released from the pump.
Tighten the drain hose (21).
Stop the engine. Slowly lower the boom until