TORQUE CONVERTER GP 1279170 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
1 1287794 BOLT
1 1287796 BOLT In addition, lock wire and dealer sealfor resealing Fuel Ratio Control and Fuel Pump are needed.ACTION REQUIRED
Emission label rework
No Dealer action is needed for the EPA label,unless the Dealer is on record as the Owner of the machine. Each OwnerNotification Letter includes an Engine Emission Label, and requests thecustomer to apply it to the valve cover on the engine of the Affected Machine.In cases where the Dealer is the machine owner(Dealer inventory, rental fleet, etc.), the Dealer will receive the OwnerNotification Letter, and is expected to install the label. If unit hasbeen sold, and the Dealer receives the Owner Notification Letter, the Dealeris expected to inform the Customer and forward the Owner Notification Letterand label for the Customer to install. For any EPA questions, Dealers maycall Product Support 309-578-4604.Tamper resistant bolt rework Please verify the factory fuel settinghas not been tampered with by checking the factory seal and lock wire.If the seal and wire are intact, proceed with the following steps. If theseal is broken, contact Tony King 309-578-4604 at Caterpillar for additionalinformation.
Remove the 5P6945 Bolt and 5P0537 Washer fromthe 1115162 Fuel Ratio Control Group and install a 1287794 Tamper ResistantBolt and reuse the washer.
Remove the 6V5894 Bolt and 5P0537 Washer fromthe 1288806 Fuel Pump Group, and install a 1287796 Tamper Resistant Boltreusing the washer.
Tighten the bolt until the head shears off (approximately12 Nm).
Install lock wire through the holes in the tamperresistant bolts and attach dealer seal.
OWNER NOTIFICATION
U.S. and Canadian owners will receive the attachedOwner Notification.SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts Labor Hrs. Parts Labor Hrs. Parts Labor Hrs.
100% 1.0 0 0 0 0
This is a 1.0-hour job. U.S. and Canadian Dealers Only - Eligibledealers may enter a Type 2 SIMS ReportPARTS DISPOSITION
Handle the parts in accordance with your WarrantyBulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAMAS SOON AS POSSIBLE.Attach. (1-Owner Notification)COPY OF OWNER NOTIFICATION FOR U.S. AND CANADIAN OWNERS
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999PRIORITY - PRODUCT IMPROVEMENT PROGRAM FORINSTALLING TAMPER RESISTANT BOLTS AND EMISSION LABELSMODELS INVOLVED - CERTAIN 330B L HYDRAULICEXCAVATORS, D6R, D6R XL, D6R LGP, D6R DS L, AND D7R DS TRACK TYPE TRACTORSDear Caterpillar Product Owner:The 1997 engine installed in your machine listedbelow is certified to meet the Environmental Protection Agency's non-roademission regulations. However, the engine may have been shipped withoutthe appropriate tamper resistant bolts on the fuel ratio control and pump.Contact your local Caterpillar dealer immediatelyto schedule this service to the products listed below. The dealer willadvise you of the time required to complete the service. Please refer tothe dealer Service Letter when scheduling this service. There is no chargefor this service.Your machine may also be missing the EPA emissioncertification label. Please apply the enclosed Emission Label to the valvecover of the engine or a flat place on the engine where the label couldbe easily viewed after application. Peel the backing from the self-sticklabel, and apply it to a clean, dry area of the engine valve cover (TOPCOVER OF THE ENGINE) or wherever is appropriate. Remove the clear laminatecover and place it over -the emission label.__ If the engine