TORQUE WRENCH 1328119 - Caterpillar

Illustration 1 g01215300
Illustration 2 g01215303
Attach a suitable lifting device to both ends of stick cylinder (1). The weight of stick cylinder (1) is approximately 308 kg (680 lb).
Disconnect hose assemblies (4). Remove bolt (3) and pin assembly (2). Remove bolt (5) and pin assembly (6).
Remove stick cylinder (1). Disassembly and Assembly Information
Table 1
Required Tools
Tool Part Number Part Description Qty
A 127-4904 Hydraulic Cylinder Repair Stand Gp 1
B 1P-0510 Driver Gp 1
C - Loctite 609 -
D 5P-0960 Grease Cartridge 1
E 9U-5337 Bearing Puller Adapter 1
4C-9634 Puller Stud 1
9U-6832 Full Nut 1
350-7768 Electric Hydraulic Pump Gp
115V 1
350-7769 Electric Hydraulic Pump Gp
230V 1
6V-3175 Double Acting Cylinder 1
6V-2098 Press Sleeve 1 Note: Use Tooling (E) in order to remove bearings (5) and (6) from the head end and the rod end of the cylinder.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Illustration 3 g03586916Note: Apply a light film of hydraulic oil to all components before assembly.
Lubricate face and threads (2) with hydraulic oil before assembly.
Using Tooling (A) tighten locknut (1) to a torque of 10800 550 N m (7966 406 lb ft).
Apply clean hydraulic oil on the lip of seal (3) and (9).
Lubricate bearing sleeve (4) with Tooling (D) prior to assembly.
Stop (7) must have 0.50 0.26 mm (0.020 0.010 inch) lineal movement after assembly.
Slit of ring (8) must turn in the direction of the piston.
Apply Tooling (C) to wiper seal groove (10) prior to assembly.
Use Tooling (B) to install bearings (5) and (6) that are located on the head end and the rod end of the cylinder. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
D 5P-0960 Grease Cartridge 1
Illustration 4 g01215300
Illustration 5 g01215303
Attach a suitable lifting device to both ends of stick cylinder (1). The weight of stick cylinder (1) is approximately 382 kg (842 lb). Position stick cylinder (1) onto the machine.
Apply Tooling (D) to pin assembly (2). Install pin assembly (2) and bolt (3). Apply Tooling (D) to pin assembly (6). Install pin assembly (6) and bolt (5).
Connect hose assemblies (4).
Fill the hydraulic oil tank. Refer to Operation and Maintenance Manual, "Hydraulic Oil Level - Check".