TORQUE CONVERTER GP 1463329 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC) - Change" or Operation and Maintenance Manual, "Cooling System Extended Life Coolant - Change" for the proper procedure.
Illustration 1 g01804054
Remove tube (1) .
Illustration 2 g01803939
Loosen clamp (2) and disconnect hose (3) from the water pump inlet.
Illustration 3 g01803941
Remove bolts (7). The bolts are different lengths. Note the positions of the different bolts.Note: Do not remove bolts (10) at this time.
Remove water pump (6) from front cover (3) .Note: If necessary, tap water pump (6) with a suitable soft hammer in order to loosen water pump (6) .
Remove gasket (5) .
If necessary, remove cover (9) from water pump (6). Follow Steps 7.a through 7.c in order to remove cover (9) .
Remove bolts (10) .
Remove cover (9) .
Remove gasket (8) .Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Guide Stud
M8 - 80 mm by 50.8 mm     2    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 4 g01803941
If necessary, install cover (9) to water pump (6). Follow Steps 1.a through 1.d in order to install the cover.
Clean the mating surface of cover (9) .
Position a new gasket (8) onto water pump (6) .
Install cover (9) to water pump (6) .
Install bolts (10) to cover (9). Tighten the bolts finger tight.
Clean the mating surface of front cover (4) .
Illustration 5 g01803975
Install Tooling (A) .
Use Tooling (A) in order to align new gasket (5) to front cover (4). Install gasket (5) to the front cover.
Align water pump (6) with Tooling (A). Install water pump (6) to front cover (4) .Note: Ensure that the gear of water pump (6) and the gear of the fuel injection pump mesh.
Install bolts (7). Refer to Illustration 4. Tighten bolts (7) finger tight.Note: Ensure that bolts of different lengths are installed in the correct positions.
Remove Tooling (A) and install remaining bolts (7) finger tight.
Illustration 6 g01515157
Tightening sequence for the water pump
Tighten bolts (7) and bolts (10) to a torque of 22 N m (195 lb in). Refer to Illustration 4. Tighten the bolts in the sequence that is shown in Illustration 6.
Illustration 7 g01803939
Install hose (3) to the water pump inlet. Tighten clamp (2) .
Illustration 8 g01804054
Install tube (1) .
Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC) - Change" or Operation and Maintenance Manual, "Cooling System Extended Life Coolant - Change" for the proper filling procedure.End By: Install the left side panel.