TORQUE CONVERTER GP 1T0910 - Caterpillar

Illustration 1 g01185738
Output transfer gears (1) Case assembly (2) Drive gear (3) Bearings (4) Shims (5) Shaft (6) Gear (7) Yoke assembly (8) Yoke assemblyThe output transfer gears are at the output side of the transmission. The transmission output shaft is connected to drive gear (2) by splines.Drive gear (2) is engaged with gear (6). Driven gear (6) is connected to shaft (5) by splines. Yoke assembly (7) and yoke assembly (8) are connected to shaft (5) by splines. Yoke assembly (7) is connected to the short drive shaft that goes to the rear differential. Yoke assembly (8) is connected to the drive shaft that goes to the bearing cage and then to the front differential.The flow of power through the output transfer gears is:
From the transmission output shaft to drive gear (2) .
From drive gear (2) to driven gear (6) .
From driven gear (6) to shaft (5) .At shaft (5) the flow of power divides as follows:
Part of the power flows from yoke assembly (7) through a drive shaft to the rear differential.
Part of the power goes from yoke assembly (8) through a drive shaft and bearing cage to the front differential.Shims (4) are used to make an adjustment to the endplay of gear (2) .Output Transfer Gear Lubrication
Since the output transfer gear case is also the reservoir for the transmission circuit, all return oil flows to the bottom of the case. The movement of the gears in the oil causes oil to be thrown on all the components.