TORQUE CONVERTER GP 1T1934 - Caterpillar

Illustration 19 g03589239
(13) 433-6947 Tube As
(14) 433-6953 Hose As
Illustration 20 g03589261
View G-G
(10) 373-7055 Tube As
(14) 433-6953 Hose As
(15) 103-1303 Half Clamp
(21) 1P-3705 Rectangular Seal
(27) 5P-8077 Half Flange
(33) 8T-4122 Hard Washer
(34) 8T-4132 Nut
(36) 8T-4140 Bolt
(38) 8T-4193 Bolt
Secure tube (10) with clamps (15).
Connect hose (14) to tube (10).
Illustration 21 g03589286
View H-H
(1) 7I-8640 Half Clamp
(2) 7V-9973 Spacer
(5) 159-8759 Block
(13) 433-6947 Tube As
(14) 433-6953 Hose As
(23) 1P-5767 Half Flange
(38) 8T-4193 Bolt
(39) 8T-4194 Bolt
(41) 8T-4223 Hard Washer
(43) 9X-8257 Washer
Connect hose (14) to tube (13) and secure to the machine.
Illustration 22 g03589321
View J-J
(1) 7I-8640 Half Clamp
(2) 7V-9973 Spacer
(5) 159-8759 Block
(13) 433-6947 Tube As
(16) 139-1398 Clip
(20) 1P-3704 Rectangular Seal
(23) 1P-5767 Half Flange
(24) 4D-6466 Clip
(26) 5P-0048 Cover
(32) 8T-4121 Hard Washer
(35) 8T-4133 Nut
(38) 8T-4193 Bolt
(39) 8T-4194 Bolt
(40) 8T-4195 Bolt
(41) 8T-4223 Hard Washer
(43) 9X-8257 Washer
Secure tube (13) to the machine.
Illustration 23 g03591262
(C) 360-8200 Valve Wiring Group (Existing)
(8) 349-9267 Control Valve Gp
Install existing 360-8200 Valve Wiring Group (C) to control valve (8).
Illustration 24 g03725338
Inside cab
(D) 290-1262 Cushion
(6) 290-1265 Cover
(7) 282-6686 Cover
(9) 361-6015 Handle Control Gp
Install handle control group (9) in the right side console group.
Remove cushion (D) from existing covers and remove existing covers. Install covers (6) and (7). Install cushion (D) onto new covers.Pressure Test
Illustration 25 g03677964
(P1) Point to measure pressure
(P2) Point to measure pressure
(S) SolenoidMeasure pressure on point (P1) and (P2). If the corresponding solenoid is de-energized, the pressure should be close to pilot pressure, approximately . 3500 kPa (500 psi). When the corresponding solenoid is energized, the pressure reading should be close to tank pressure, approximately 300 kPa (45 psi).