TORQUE CONVERTER GP 2326207 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite Gasket Sealant No. 2 -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Replace the gasket.
Apply Tooling (A) to the bottom portion of the gasket.
Illustration 1 g00549821
If necessary, install the studs (not shown) to the back of the front housing (2) that holds the fuel injection pump in position. Tighten the studs to a torque of 11 N m (97 lb in). Install the gasket and front housing (2). Cut the gasket to the correct length, if necessary.
Install bolts (3) that hold the engine oil pan to the bottom of the front housing. Tighten the bolts to a torque of 22 N m (16 lb ft).
Illustration 2 g00549819
Illustration 3 g03549798
Install all bolts (1) that fasten the front housing (2) to the cylinder block and to the oil pan. Tighten bolts (1) to a torque of 22 N m (16 lb ft) using the sequence in Illustration 3.Note: Ensure that the bottom of the front housing is aligned with the bottom of the cylinder block.End By:
Install the camshaft gear.
Install the front gear group.
Install the engine oil pan.