TORQUE CONVERTER AR 3590403 - Caterpillar

Illustration 1 g00697157
Enter a valid "User Name" and enter a valid "Password". After the password has been entered, click the "OK" button. The menu option will change. The menu bar will now contain an "Op. Params." option.
Select "Op. Group 6: Disable Auto Start / Modem Enable".
Set the "Operating Parameter Modem Enable" to a value of "1" and press "Send".
Select the "Op. Group 6: Disable Auto Start / Modem Enable" from the "Op. Params." pull-down menu.
Select the type of the modem that is being installed from the list in Table 1. Enter the value for the type of Modem and press "Send".
Table 1
Types of Modems    
Number    Type    
0     Internal Socket Modem (US and Canada)    
1     Internal Socket Modem (Europe)    
2     "US Robotics (Courier) V. Everything External"    
3     "Multi-Tech Multi Modem II"    Note: The "US Robotics" and "Multi-Tech" modems are the only two external modems that have been qualified to operate with the UPS. The "US Robotics" and "Multi-Tech" modems are used in countries that have not approved the internal Socket Modems. In order to use an external modem, an adapter board must be installed on the System I/O Module. The customer is responsible for providing a receptacle that is protected by the UPS in order to supply power for the modem. Connect an external modem to the adapter board with a serial cable (9 pin to 25 pin).The switches are the dual in-line package (DIP). The switches must be set to match to values that are listed in Table 2.
Table 2
Switch settings for the "US Robotics" Modem    
Switch    Position    
1     ON ("DTR Always On")    
2     ON ("Numeric Result Codes")    
3     ON ("Display Result Codes")    
4     ON ("No Echo Offline Commands")    
5     OFF ("Auto Answer on Ring")    
6     OFF ("Normal Carrier Detect")    
7     OFF ("Display All Result Codes")    
8     ON ("Enable AT Command Set")    
9     OFF ("Disconnect with +++")    
10     OFF ("Load NVRAM Defaults")    
Press "Control R". Press "Y" in order to reset the UPS.
With the UPS View application, initialize the internal NVRAM for the modem by entering "Control-Q" after the UPS resets. After the NVRAM has been initialized, the screen should show the current settings for the modem. If the screen displays "Modem Error - Modem not responding", enter the "Control-Q" again. If the modem does not respond, check the cables and check the power supplies.
Use the front display panel of the UPS in order to enter the "pager numbers" and the "callback numbers". Use the front display panel of the UPS in order to change "pager numbers" and the "callback numbers". If paging is not desired, leave the pager number set to all blanks.Setting Up the Pager Silence Interval
The Pager Silence Interval is the function that allows the paging service to complete the "Welcome Message" before the message for the numeric page is input.
From