TORQUE CONVERTER & HOUSING GP 3904072 - Caterpillar

Set "Modbus TCP/2W/4W" to 0 for Modbus/TCP.Note: Modbus/TCP uses standard port 502.Half-duplex (2 wire)
Illustration 5 g00934345
Set "Modbus TCP/2W/4W" to "1" for Half-duplex.
Illustration 6 g00934347
Illustration 7 g00934348
Set "Modbus Unit ID". The range is from 1 to 247.
Illustration 8 g00934350
Set "Modbus Baud Rate" to 9600 baud or 19200 baud.
Illustration 9 g00934374
Illustration 10 g00934353
Put jumper "JMPA" to the "RS485" position on connector "J1".Note: Connector "J1" is located on the System Input/Output Daughter Board (SIOD).
Connect a jumper wire between terminal 2 and terminal 3.
Connect terminal 2 and terminal 3 to the positive terminal of the equipment that is being monitored.
Illustration 11 g00934354
Connect a jumper wire between terminal 4 and terminal 5.
Connect terminal 4 and terminal 5 to the negative terminal of the equipment that is being monitored.
Connect terminal 1 and/or terminal 6 to the ground of the equipment that is being monitored.Full Duplex (4 wire)
Illustration 12 g00934345
Set "Modbus TCP/2W/4W" to "2" for a Full Duplex.
Illustration 13 g00934347
Illustration 14 g00934348
Set the "Modbus Unit ID".The range is from 1 to 247.
Illustration 15 g00934350
Set "Modbus Baud Rate" to 9600 baud or 19200 baud.
Illustration 16 g00934374
Illustration 17 g00934686
Put jumper "JMPA" to the "RS485" position on connector "J1".Note: Connector "J1" is located on the System Input/Output Daughter (SOID) Board.
Connect terminal 2 to the "RX+" terminal of the equipment that is being monitored.
Connect terminal 4 to the "RX-" terminal of the equipment that is being monitored.
Connect terminal 3 to the "TX+" terminal of the equipment that is being monitored.
Connect terminal 5 to the "TX-" terminal of the equipment that is being monitored.
Connect terminal 1 and/or terminal 6 to the ground of the equipment that is being monitored.