TORQUE CONVERTER GP 4532041 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Drain the cooling system until the level of the coolant is below the exhaust manifolds.
Illustration 1 g00624685
Disconnect hose (1) from the water temperature regulator housing. Unless the hose will be replaced, leave the hose attached to the aftercooler.
Illustration 2 g00602196
Disconnect two tubes (2) from the water temperature regulator housing.
Illustration 3 g00602197
Typical example
Attach Tool (A) and a suitable lifting device. Remove bolts (3). Remove water temperature regulator housing (4).
Illustration 4 g00602198
Remove four water temperature regulators (5). Remove gasket (6). Visually inspect ferrule (7) and the seals for water temperature regulators (5). Obtain new parts for assembly, if necessary.