TORQUE CONVERTER & HOUSING GP 4542330 - Caterpillar

Illustration 9 g02424802
Install Plate (1) With Bushing (7) and Bolt (8) .
Select two or three hole locations and install 188-3915 Bushings (7) and 8T-4186 Bolt (8) to fasten the drilling plate to the cylinder head. In some cases, the exhaust stud and a nut can be used in place of the M10 bolts.Note: Due to the large number of holes in the drilling plate, the holes are not marked for specific bolt locations and some adjacent studs must be removed to provide clearance for the plate. On 3126B cylinder heads, the small allen head plugs must be removed to allow the plate to sit flush on the cylinder head. If the plugs are removed, discard the O-rings and replace them with new O-rings.
Illustration 10 g02424803
Make Sure Fastener is Centered in Hole.
Make sure the fastener being removed is centered in the hole of the drilling plate.
The exhaust manifold fasteners are taper lock studs. These studs normally do not have a large air space between the end of the stud and the bottom of the hole. It is important to check the depth of an adjacent hole to set the drill depth. Drilling too deep will cause cylinder head damage.
Illustration 11 g02424804
Check Depth of Adjacent Hole and Mark Depth on Drill Bit.
Check the depth of the hole using an identical hole and mark 1U-8133 Drill Bit (6) to avoid drilling too deep.
Illustration 12 g02424805
Install Drill Bushing (6) with Lock Screw (2) .
Install 188-3918 Bushing (6) in the drilling plate and secure it with a 188-3915 Bushing Screw (2) .
Illustration 13 g02424806
Drill Pilot Hole with Drill Bit (4) .
Drill a pilot hole in the broken stud with 1U-8133 Drill Bit (4) .
Illustration 14 g02424807
Check the depth of the hole of an adjacent hole and mark 1U-8163 Drill Bit (3) to avoid drilling too deep.
Illustration 15 g02424808
Install Drill Bushing (5) with Lock Screw (2) .
Install 188-3923 Bushing (5) and bushing lock screw (2) .
Illustration 16 g02424809
Drill Out Broken Fastener with Drill Bit (3) .
Install 188-3923 Bushing (5) and bushing lock screw (2) .
Illustration 17 g02424810
Use a pick or other suitable device to remove any remaining metal chips.
Illustration 18 g02435361
Illustration 19 g02424811
Using a tap, recondition the threads.
Illustration 20 g02435360
Clean the threaded hole to remove all debris.