TORQUE CONVERTER GP 9U9068 - Caterpillar

Illustration 1 g02188476
Bolt locations
Illustration 2 g02589876
Left side view
Table 1
Specification for 101-0836 Flywheel Housing Gp, 297-7000 Flywheel Housing Gp, 383-6541 Flywheel Housing Gp, 384-8033 Flywheel Housing Gp, and 7W-3722 Flywheel Housing Gp
Item Qty Part Specification Description
Before installation of the flywheel housing, inspect the front face of the flywheel housing and the rear face of the cylinder block. The components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign materials.
To seal the joint between the flywheel housing and the cylinder block, apply Loctite High Flex GM to the front face of the flywheel housing.
1 6 9X-8873 Bolt Length of 1/2 inch diameter bolt is 57.15 mm (2.250 inch).
Torque to 135 20 N m (100 15 lb ft).
2 4 9X-8875 Bolt Length of 1/2 inch diameter bolt is 88.90 mm (3.500 inch).
Torque to 135 20 N m (100 15 lb ft).
3 2 9M-7269 (1) Length of 1/2 inch diameter bolt is 171.5 mm (6.75 inch).
Torque to 135 20 N m (100 15 lb ft).
6M-9613 (2) Length of 1/2 inch diameter bolt is 228.6 mm (9.00 inch).
Torque to 135 20 N m (100 15 lb ft).
4 2 9S-1374 Bolt Length of 1/2 inch diameter bolt is 203.20 mm (8.000 inch).
Torque to 135 20 N m (100 15 lb ft).
5 4 8S-9089 Bolt Length of 1/2 inch diameter bolt is 114.30 mm (4.500 inch).
Torque to 135 20 N m (100 15 lb ft).
6 16 1D-4590 Bolt Length of 5/8 inch diameter bolt is 120.65 mm (4.750 inch).
Torque to 270 40 N m (199 30 lb ft).
7 - - Apply blue Loctite High Flex GM to the surface of the gasket before assembly.
(1) This bolt is used if the engine is not equipped with a support bracket for the air lines.
(2) This bolt is used if the engine is equipped with a support bracket for the air lines.