TOWEL-SHOP 3039339 - Caterpillar

Table 3
Required Tools    
Tool    Part Number    Part Description    Qty    
B     138-7575     Link Bracket     1    
C     2P-8312     Pliers     1    
D     4C-6408     Axle Support     1    Note: Thoroughly clean all of the components prior to installation.
Illustration 8 g01090921
Attach a suitable lifting device to the axle shaft. The weight of the axle shaft is approximately 41 kg (90 lb). Install the axle shaft in the final drive. Slide Tooling (D) over the end of the axle shaft, as shown. Use Tooling (D) to guide the axle shaft in position in the final drive.
Illustration 9 g01090930
Align sun gear (9) with the planetary gears and slide the sun gear completely on the axle shaft. Remove Tooling (D) .
Illustration 10 g01090936
Use Tooling (C) to install retaining ring (10) .
Illustration 11 g01085711
Remove bolt (5). Attach Tooling (B) to cover assembly (2). Install cover assembly (2) and the O-ring seal. Install bolts (1). Remove Tooling (B). Tighten bolts (1) to a torque of 105 20 N m (77 15 lb ft). Attach a suitable lifting device to bar assembly (4). The weight of bar assembly (4) is approximately 161 kg (355 lb). Install bar assembly (4). Remove bolt (6). Install bolt (6) with the spacer. Install bolts (7). Install pin assembly (3) .
Fill the axle housing with oil. Refer to Operation and Maintenance Manual, "Differential and Final Drive Oil - Change".Installation Procedure for the 824H Wheel Dozer and the 826H Landfill Compactor
Table 4
Required Tools    
Tool    Part Number    Part Description    Qty    
C     2P-8312     Pliers     1    
D     4C-6408     Axle Support     1    Note: Thoroughly clean all of the components prior to installation.
Illustration 12 g01090944
Attach a suitable lifting device to the axle shaft. The weight of the axle shaft is approximately 41 kg (90 lb). Install axle shaft (5) in the final drive. Slide Tooling (A) over the end of the axle shaft, as shown. Use Tooling (A) to guide the axle shaft in position in the final drive.
Illustration 13 g01090952
Align sun gear (6) with the planetary gears and slide the sun gear completely on the axle shaft. Remove Tooling (A) .
Illustration 14 g01089329
Use Tooling (C) to install retaining ring (7) .
Illustration 15 g00518582
Install O-ring seal (4) in the groove of the final drive assembly.
Illustration 16 g00518550
Install cover assembly (2), six bolts (1) and the washers. Tighten the bolts to a torque of 105 20 N m (77 15 lb ft).
Install drain plug (3) .
Fill the axle housing with oil. Refer to Operation and Maintenance Manual, "Differential and Final Drive Oil - Change".