AVSPARE.COM
parts catalog

TRACK ADJUSTER & RECOIL GP 2394367 - Caterpillar


2394367 TRACK ADJUSTER & RECOIL GP Caterpillar parts 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 326D L
Rating:
75
Alternative (cross code) number:
CA2394367
239-4367
2394367
Caterpillar 2394367 TRACK ADJUSTER & RECOIL GP

Buy TRACK ADJUSTER & RECOIL GP 2394367 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, MOBILE HYD POWER UNIT,

Compatible equipment models: 2394367:

MOBILE HYD POWER UNIT  324D LN   Caterpillar
Number on catalog scheme: 2
 
  For full view, you need register

Information:


Illustration 1 g00920112
Schematic of the Proportional Solenoid (Apron Lower)
This diagnostic code is associated with the Proportional Solenoid (Apron Lower). The FMI 03 means that the ECM has determined that the voltage of the solenoid circuit is above normal. The possible causes of the diagnostic code are listed:
The solenoid has failed.
The energize circuit of the solenoid is shorted to the +battery circuit.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1278 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code occurs, a warning (Category 1) is shown on the monitor. The diagnostic code will cause all commands for the apron to be disabled. When this diagnostic code is active, the hydraulic supply for the pilot is shut off.Note: When this diagnostic code goes away the operator must move the lever for the apron to the neutral position for two seconds before commands will be allowed.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the solenoid and the ECM.
At the machine harness connector for the ECM, measure the resistance from contact J2-3 (wire R770-BR(Brown)) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-3 (R770-BR(Brown)) and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE.
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 1278 FMI 03 is active. Expected Result:The CID 1278 FMI 03 is active.Results:
YES - The CID 1278 FMI 03 is active. The problem has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NO - The CID 1278 FMI 03 is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation.STOP

Caterpillar SIS machinery equipment:

Caterpillar SIS
326D2 L Excavator LCW00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326F L Excavator TMR00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L OEM HM400001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L Excavator KER00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326F L Excavators EBK00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L Excavator JFG00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L Excavator LJE00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326F L & 326F LN Excavators GGJ00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D & 324D L Excavators CJX00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D L & LN Excavator EJC00001-UP (MACHINE) POWERED BY C-7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D L Excavator T2D00001-UP (MACHINE) POWERED BY C-7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D L Hydraulic Excavator JJG00001-UP (MACHINE) POWERED BY C-7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D L Excavator LAB00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D LN Mobile Hydraulic Power Unit KJR00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D & 324D L Excavators JZR00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D & 324D L Excavators JAT00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D L Excavator PYT00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D L & 324D LN Excavators BTK00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324E L Excavator PNW00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324E L & 324E LN Excavators LDG00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324E & 324E L Excavators JCZ00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
324D L Excavator GPK00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D L Excavator PJM00001-UP (MACHINE) POWERED BY C7 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 & 326D2 L Excavators KGY00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L Excavator REC00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L Excavators JFL00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326F L Excavator WGL00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326F L & 326F LN Excavators HCJ00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L Excavator XAM00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP
326D2 L Excavator MZH00001-UP (MACHINE) POWERED BY C7.1 Engine » 239-4367 TRACK ADJUSTER & RECOIL GP

Caterpillar parts catalog:

Caterpillar parts catalog
326D2 L Excavator LCW00001-UP (MACHINE) POWERED BY C7.1 Engine
326F L Excavator TMR00001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L OEM HM400001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L Excavator KER00001-UP (MACHINE) POWERED BY C7.1 Engine
326F L Excavators EBK00001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L Excavator JFG00001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L Excavator LJE00001-UP (MACHINE) POWERED BY C7.1 Engine
326F L & 326F LN Excavators GGJ00001-UP (MACHINE) POWERED BY C7.1 Engine
324D & 324D L Excavators CJX00001-UP (MACHINE) POWERED BY C7 Engine
324D L & LN Excavator EJC00001-UP (MACHINE) POWERED BY C-7 Engine
324D L Excavator T2D00001-UP (MACHINE) POWERED BY C-7 Engine
324D L Hydraulic Excavator JJG00001-UP (MACHINE) POWERED BY C-7 Engine
324D L Excavator LAB00001-UP (MACHINE) POWERED BY C7 Engine
324D LN Mobile Hydraulic Power Unit KJR00001-UP (MACHINE) POWERED BY C7 Engine
324D & 324D L Excavators JZR00001-UP (MACHINE) POWERED BY C7 Engine
324D & 324D L Excavators JAT00001-UP (MACHINE) POWERED BY C7 Engine
324D L Excavator PYT00001-UP (MACHINE) POWERED BY C7 Engine
324D L & 324D LN Excavators BTK00001-UP (MACHINE) POWERED BY C7 Engine
324E L Excavator PNW00001-UP (MACHINE) POWERED BY C7.1 Engine
324E L & 324E LN Excavators LDG00001-UP (MACHINE) POWERED BY C7.1 Engine
324E & 324E L Excavators JCZ00001-UP (MACHINE) POWERED BY C7.1 Engine
324D L Excavator GPK00001-UP (MACHINE) POWERED BY C7 Engine
326D L Excavator PJM00001-UP (MACHINE) POWERED BY C7 Engine
326D2 & 326D2 L Excavators KGY00001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L Excavator REC00001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L Excavators JFL00001-UP (MACHINE) POWERED BY C7.1 Engine
326F L Excavator WGL00001-UP (MACHINE) POWERED BY C7.1 Engine
326F L & 326F LN Excavators HCJ00001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L Excavator XAM00001-UP (MACHINE) POWERED BY C7.1 Engine
326D2 L Excavator MZH00001-UP (MACHINE) POWERED BY C7.1 Engine


Parts track Caterpillar catalog:

2394418 TRACK ADJUSTER & RECOIL GP
324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 326D L
3408233 TRACK AR
324E, 324E L, 324E LN
3408234 TRACK AR
324E, 324E L, 324E LN
9W1916 TRACK GP
225, 229, 229D, 231D, D7H
6Y3868 TRACK GP
933, 933C, D3G
6Y2758 TRACK GP
330, 330 FM L, 330 L, OEMS
2639239 TRACK GP
304C CR, 305.5D, 305.5E, 305C CR, 305D CR, 305E
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.