TRACK GP 2414897 - Caterpillar

Illustration 34 g02175137
Install friction discs and clutch plate (28). Install ring gear (30).
Illustration 35 g02175496
Install reaction plate (33), friction discs (31), and clutch plates (34).Note: The friction discs and the clutch plates from the individual clutches must be kept in the correct order. The friction discs and the clutch plates must be kept with the original clutch housings. The different clutches use different friction material. The friction discs and the clutch plates must not bemixedtogether.
Illustration 36 g02176353
Install housing assembly (32) to ring gear (30). Install retaining ring (29) to ring gear (30).Note: Ensure that housing assembly (32) and ring gear (30) are correctly aligned before you install retaining ring (29).
Illustration 37 g02175535
Install dowels (27) and springs (26).
Install O-ring seals (25).
Illustration 38 g02168876
Install bearing (23) to manifold (20). Use Tooling (C) to install retaining ring (22).
Illustration 39 g02168836
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Attach Tooling (B) and a suitable lifting device to manifold (20) and position manifold (20). The weight of manifold (20) is approximately 27 kg (60 lb).
Install bolts (21). Tighten bolts (21) to a torque of 115 7 N m (85 5 lb ft).
Install retaining ring (18) and retaining ring (19).
Illustration 40 g02168643
Install bracket assembly (17) and bolts (17).
Position rotor (15). Use Tooling (C) to install retaining ring (14).
Illustration 41 g02416157
Position and install valve assembly (13). Tighten bolts (12) to a torque of 25 6 N m (19 4 lb ft).
Illustration 42 g02415120
Install valve assemblies (10), retainers (9), and bolts (8). Tighten bolts (8) to a torque of 30 4 N m (22 3 lb ft).
Install drain assemblies (11). Tighten drain assemblies to a torque of 9 1 N m (80 9 lb in).
Install harness assembly (7).
Illustration 43 g02415082
Install connector (4) into the case. Install locknut (3).
Install tubes (6) and the O-ring seals.
Install fittings (5) and the O-ring seals.
Illustration 44 g02415057
Install O-ring seals (1) and (2) to the transmission cover.
Remove the transmission from Tooling (A). The weight of the transmission is approximately 458 kg (1010 lb).End By:
Connect the transmission and bevel gears.