TRACK GP 2893070 - Caterpillar

2893070 TRACK GP Caterpillar parts D4G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2893070
289-3070
2893070

Buy TRACK GP 2893070 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compatible equipment models: 2893070:

TRACK-TYPE TRACTOR D4G Caterpillar

For full view, you need register

Information:

Illustration 3 g01212479
P1 ECM connector (P1-2) 5 V sensor supply (P1-3) Sensor return (P1-4) 8 V supply (P1-5) Digital return (P1-7) Coolant temperature sensor (P1-11) Left exhaust temperature (P1-12) Right exhaust temperature (P1-16) Filtered engine oil pressure sensor (P1-17) Unfiltered engine oil pressure sensor (P1-24) Filtered fuel pressure (P1-25) Unfiltered fuel pressure
Illustration 4 g01288476
P2 ECM connector (P2-36) Turbocharger outlet pressure sensor (P2-37) Atmospheric sensor (P2-38) Left turbocharger inlet pressure sensor (P2-39) Right turbocharger inlet pressure sensor (P2-46) Crankcase pressure sensor
Illustration 5 g01094844
Sensor connector (Pin A) Sensor supply (Pin B) Sensor return (Pin C) SignalTest Step 1. Inspect Electrical Connectors and Wiring
Turn the "main disconnect switch (MDS)" to the OFF position.
Thoroughly inspect the J1/P1 ECM connector and the J2/P2 ECM connector. Inspect all of the connectors that are associated with the circuit.Refer to Troubleshooting, "Inspecting Electrical Connectors" for details.
Perform a 45 N (10 lb) pull test on each of the wires in the ECM connectors that are associated with the circuit.
Check the ECM connector (allen head screw) for the proper torque. Refer to Troubleshooting, "Inspecting Electrical Connectors" for details.
Check the harness and wiring for abrasion and for pinch points from the sensors back to the ECM.Expected Result:All connectors, pins and sockets are completely coupled and/or inserted and the harness and wiring are free of corrosion, of abrasion and of pinch points.Results:
OK - The harness and connectors appear to be OK. Proceed to Test Step 2.
Not OK - There is a problem with the connectors and/or wiring.Repair: Repair the connectors or wiring and/or replace the connectors or wiring. Ensure that all of the seals are properly in place and ensure that the connectors are completely coupled.Verify that the repair eliminates the problem.STOPTest Step 2. Check for Active Diagnostic Codes
Connect Caterpillar Electronic Technician (ET) to the service tool connector.
Turn the