TRACK-RUBBER 3258624 - Caterpillar

Remove Flywheel
START BY:a) separation of generator from engine 1. Fasten tool (A) to flywheel (2) as shown.2. Remove bolts (1) and flywheel (2) from the engine. The weight of the flywheel is 54 Kg (120 lb.). 3. If necessary remove gear (3) from flywheel (2).Install Flywheel
1. Heat gear (2) to a maximum temperature of 315°C (600°F) and install it on flywheel (1) so the chamfer of the gear teeth will be toward the crankshaft when flywheel (1) is installed. 2. Install a 5/8"-11 NC x 8" guide bolt (3) in the crankshaft as shown. 3. Fasten tool (A) to flywheel (1) and put it in position on the engine.4. Put clean engine oil or 5P960 Multipurpose Type Grease on the threads of the bolts and install them to hold the flywheel. Tighten the bolts to a torque of 270 27 N m (200 20 lb.ft.).END BY:a) connection of generator to engine